Maxxima MRL-61350NW-4 5 Inch and 6 Inch LED Retrofit Kit Instruction Manual
- June 4, 2024
- Maxxima
Table of Contents
Maxxima MRL-61350NW-4 5 Inch and 6 Inch LED Retrofit Kit
5″ & 6″ LED Retrofit-Kit Installation Instructions
The units covered in these instructions are intended to retrofit Type IC or
Type Non-IC luminaires
WARNING / ATTENTION:
- Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR AUTHORITIES HAVING JURISDICTION.
CAUTIONS:
- 1. For your safety read and understand instructions completely before starting installation
- Before attempting Installation, check your local electric code, as it sets wiring standards for your locality.
NOTES:
-
. If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire
is connected to the switch. DO NOT connect the white supply wire to the switch. -
2. Make sure no bare wires are exposed outside the wire nut connectors.
-
3. Do not make or alter any open holes in an enclosure of wiring or electrical components during kits installation.
-
4. This lamp is not compatible with photo controls, occupancy sensors, or timing devices.
Electrical parameters
| Model | Input Voltage (V) | Input Wattage (W) |
|---|---|---|
| MRL-615205 | 120 | 14 |
Product Dimensions
NOTE: Torsion springs are pre-installed for 6″ housing compatibility. For use in 5″ housing move both springs to the inner position using a philips screwdriver.
Installation Into Recessed Housing
- STEP1: Turn off the power before installation. Remove the existing diffuser, bulb and trim as applicable.
- STEP2: Screw E26 socket adapter into socket in housing. (Figure 1)
- STEP3: Plug the connector of the retrofit kit into the connector of the socket adapter assembly. (Figure 2)
- STEP4: Use the CCT Selector Switch on the back of the fixture to select the desired color of the light.
- STEP5: Squeeze the torsion springs together and install into torsion spring brackets inside the housing as shown. (Figure 3)
- STEP6: Tuck all wires into the housing and carefully push the LED trim until its outer edge is flush against the ceiling surface. (Figure 4)
Three-Year Warranty
Maxxima extends a 3-year limited warranty to the original purchaser that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warranted product to the original consumer/ purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. A limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>