DKS Doorking 1601-800 Octagonal Lighted Signal Arm Installation Guide
- June 9, 2024
- DKS
Table of Contents
DKS Doorking 1601-800 Octagonal Lighted Signal Arm
This kit is designed for a 1601 barrier gate operator OR 1603 auto-spikes barrier operator. It CANNOT be used with a LED/Reverse Edge. It ONLY works with a 1-Piece 14 ft octagon arm with a STANDARD arm bracket, NOT a Break-Away bracket. It will extend a 14 ft arm an extra two feet. The OPTIONAL 2-ft extension MUST be installed WITH the counterweight to balance the extra weight of the extension.
Installation instruction
Install End Cap
Push a screwdriver through the hole in cap to release spring while pushing cap on. Keep pushing cap on until a “CLICK” is heard, locking it in place.
Adrees: 120 S. Glasgow Avenue Inglewood, California 90301 U.S.A
Documents / Resources
| DKS
Doorking 1601-800 Octagonal Lighted Signal
Arm
[pdf] Installation Guide
Doorking 1601-800 Octagonal Lighted Signal Arm, Octagonal Lighted Signal Arm,
Doorking 1601-80, Lighted Signal Arm, Signal Arm, Arm
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>