ORTECH SLIM-RG4-5CCT LED Slim Lights Instruction Manual
- June 4, 2024
- Ortech
Table of Contents
Instruction Manual
LED Slim Lights
MODEL SLIM-RG4-5CCT
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED
ELECTRICIAN.
- LED Slim Lights are suitable for indoor use only. DO NOT use outdoors
- Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth when you clean them
- LED Slim Lights can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
- For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
- Turn the power off from the electrical panel before starting installation or attempting any maintenance. Indoor installation only
CAUTION
PLEASE READ THE INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN THEM
FOR FUTURE REFERENCE.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a
competent electrician.
INSTALLATION GUIDE
Tools Required
- Saw
- Measuring Tape
- Electrical Wiring (use type and gauge suitable for application to connect the fixtures)
Driver Wiring
- Open the hardwire box swing cover and remove the appropriate knockout(s)
- Insert the electrical supply cable through the knockout and secure it with a cable connector (sold separately)
- Using wire nuts, connect the GREEN ground wire of the cable to the GREEN wire on the box. Connect WHITE wire of the cable to WHITE wire of box. Connect BLACK wire of cable to BLACK wire of box (see Fig.2)
- Place all wiring and connections back into the box and close the cover
- Insert hardwire box through the mounting hole (see Fig.3).
New Construction Applications:
Hardwire box shall be firmly secured to studs, joists, or similar fixed
structural units
Remodel Applications:
DO NOT require the hardwire box to be firmly secured after the mounting
plates, studs, joists, or structural units have been concealed
Pre-installation
- Push the baffle on the module, then mount the appropriate trim on the module (see Fig.1). Twist the trim to lock on the module securely
- Turn power OFF from the electrical panel before starting the installation
- Locate a suitable position to plate the fixture and open in accordance with the cut-hole dimensions
- Run an electrical wire from the switch (power supply) through the mounting hole — use NMD90 Romex or BX cab
INSTALLATION GUIDE
Fixture Installation
- Connect light engine. Be sure to properly align connectors and fully screw down the connector cover (see Fig.4)
- Connect the fixture to the hardwire box by inserting and twisting the male / female connectors (see Fig.5)
- Push spring-loaded clips on the fixture upwards and insert the fixture base into the mounting hole. Release the clips and the fixture will be pulled flush to the ceiling (see Fig.6
- Once assembly is complete, turn ON power to confirm that fixture is working properly
Compatible Dimmer List
| BRAND | FAMILY | MODEL |
|---|---|---|
| LUTRON | SKYLARK CONTOUR | CTCL-153P |
DVCL -153PDH
CT-600P
DIVA| DVCL-153P
LEVITON| DECORA| 6672
6674
PASS & SEYMOUR| HARMONY| HCL453PTCCCV6
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components, and specifications to meet market changes.
info@ortechindustries.com
www.ortechindustries.com
13376 Comber Way
Surrey BC V3W 5V9
375 Admiral Blvd
Mississauga, ON L5T 2N1
1-888-543-6473
1-888-541-6474
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>