GROTHE ETA 64X Surface Mounted Doorbell Instruction Manual
- June 9, 2024
- GROTHE
Table of Contents
GROTHE ETA 64X Surface Mounted Doorbell
Installation
Anschluss des Protact Klingeltasters. Connection of the Protact push button
- Strip wire.
- Put wire through seal.
- Connect wire.
- Unlocking.
- Press on seal.
- Example Circuit
Montage der Aufputz-Etagenplatte. Installation of the surface-mounted shelf plate
-
Align the mounting adapter on the masonry and fix it with the supplied fixing material.
ATTENTION: The round opening shows the position of the bell push button: Top or bottom. Both mounting variants are possible. -
After fixing the mounting adapter, connect the Protact bell push button as described in point 1 and carry out a function test.
The floor plate cover is hooked in at the side and slipped over the mounting adapter. The round opening of the mounting plate must then be behind the Protact bell push button. -
The tier plate cover is secured laterally with a screw, which is screwed into the mounting adapter. The screw is then covered with a cap.
-
Insert the name tag inlay into the recess provided and carefully insert the Plexiglas cover.
-
Electrical connection:
- Lead to push-button (Power supply) 8 – 12 V AC/DC (1.5 A)
- Connection to bell (Bell wire)
- Lead to LED lighting (Ground) 8 – 12 V AC/DC (10 mA)
GROTHE GmbH I Löhestraße 22 I D-53773 Hennef [email protected] I www.grothe.de Mv556400 I Stand 05.2022