GROTHE MONTILUX 2154 Push Button User Manual
- June 10, 2024
- GROTHE
Table of Contents
GROTHE MONTILUX 2154 Push Button
Product Information
The Klingeltaster/Push button Montilux is an electronic doorbell button. It comes with a nameplate cover that can be easily removed to access the slots for installation. The push button can be connected to a power source and a LED (optional) for illumination. The installation should be performed by a qualified electrician.
Product Usage Instructions
- Using a flat screwdriver, remove the nameplate cover to access the installation slots.
- Insert a suitable screwdriver into the two slots and tilt them as described in the illustration.
- Loosen the screw with a screwdriver and insert the stripped wire under the plate. Tighten the screw again.
- If you want to connect a LED, follow the connection diagram provided in the manual.
- The installation must be carried out in a de-energized state by a qualified electrician.
Installation
Opening the housing
- To open the housing, remove the nameplate cover with a flat screwdriver.
- Two slots appear under the nameplate. Use a suitable screwdriver to pierce these two slots and tilt them as described in the illustration.
Connection of the push button
Connect the wires as follows:
- Loosen the screw with a screwdriver. Insert the stripped wire under the plate and tighten the screw again.
Connection diagram
- Installation must be carried out in de-energized condition by an electrical!
Technical data
- Max: 12 V ~ (AC/DC 50 mA – 1,5 A)
- LED: 8 – 12 V~ (AC/DC 0,01 A)
- Protect. low volt. only!
- Wire 0,6 – 0,8 mm
- -20°C…50°C
- IP41
- Op. force ca. 6 N
Grothe GmbH
- Löhestraße 22 53773 Hennef
- service@grothe.de
MV 510110
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>