OttLite CS33600C Slimline LED Desk Lamp Instruction Manual
- June 9, 2024
- OttLite
Table of Contents
OttLite CS33600C Slimline LED Desk Lamp Instruction
CONGRATULATIONS! You’ve purchased the finest in natural lighting technology with your new OttLite® product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by
mail, or register online by going to: OttLite.com/warranty
WARNING : To prevent electric shock, make sure the lamp is not plugged in
until all steps are complete.
NOTE : THIS UNIT IS FULLY ASSEMBLED
- Remove lamp from packing, placing lamp body base (A) flat on a steady surface.
- Connect power adapter input (B) into connector (C) in the rear-bottom of the lamp.
- Plug the power adapter (D) into a standard household 120V AC outlet. Note: Only use with the supplied power adapter to avoid damage or fire.
- Turn the lamp ON/OFF by using power switch (E) located on top of base (A).
- Touch switch “M” (F) to change the color temperature of the light. The lamp has 3 color modes.
- Adjust the brightness by touching the “+” (G), or the “–” (H) on the touch panel.
- To reposition the light, hold base (A) steady and grasp either lamp body (J) or shade (K) depending on needed adjustment. DO NOT FORCE the shade or lamp body outside allowable adjustable range as excessive adjustment may cause damage.
SAFETY WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
- Turn lamp off and WAIT UNTIL LAMP HEAD IS COOL before handling.
- The LED panel might get hot after several hours of continuous use DO NOT place your hands directly on LED light panel.
- Never use with an extension cord unless the plug can be fully inserted into the receptacles in the extension cord.
- Do not alter the plug.
- The lamp head included with this unit cannot be replaced by the consumer.
- INDOOR USE ONLY
NOTE: The important safety instructions appearing in this instruction
sheet are not meant to cover all possible conditions and situations that may
occur. It must be understood that common sense, caution, and care must be used
with any electrical product.
CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE IS
DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR ITS SERVICE
AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD. INDOOR USE
ONLY.
CAUTION! THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN
THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE
REPLACED.
CAUTION: Any change or modification to product not expressly recognized
by OttLite Technologies voids OttLite’s responsibility for proper function of
product.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- (1) this device may not cause harmful interference, and
- (2) this device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
POWER ADAPTER SPECIFICATION: Input: AC 100-240V, 50/60 Hz, 0.3A Output: 5V DC,
1.0A with a Male DC Plug
Slimline LED Desk Lamp
CS33600C CS336G5C CS33600C-SHPR CS336G5C-SHPR
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>