JESLED T8 4FT LED Tube User Manual
- June 9, 2024
- JESLED
Table of Contents
JESLED T8 4FT LED Tube
DUAL-END POWER LED INSTALLATI0N
Installation Warning
- Remove or disconnect ballasts and starters before installation! Failure to do so will eause irreparable damage to your new LED tube and could cause a fire!
- Rewiring of fluorescent fixtures for use with LED tubes should only be performed by individuals who have been properly trained to perform basic electrical maintenance and repair. Please review these instructions thoroughly before proceeding!
How to install this led tube?
Step 1:
Before opening and disassembling the fixture, make sure power has been turned
off at the main circuit breaker and remove the bulbs from the fixture.
Step 2:
Open your fixture and examine the wiring. You will see either Electronie
Ballast or Magnetic Ballast in your fixture. The wiring diagram for a typical
fluorescent fixture using single-pin, stationary/plunger-type sockets is shown
below step 3. Although configurations may vary, the basic concept is the same.
If you have a different wiring fixture, please contact us to
support@jesled.com.
Step 3:
Remove or bypass the ballast indicated in the diagram below: cut or disconnect
the wires in the locations indicated.
Try to leave enough wire to allow rewiring of the sockets to the line and
neutral as shown in the diagram in step 4.
Electronic Ballast Type
Magnetic Ballast Type
Step 4:
Connect the Live wire to one side (the single-wire plunger sockets) and
connect the Neutral wire to other side (the double-wire stationary sockets) as
shown below. Make sure all wire connections are wire nutted and wrapped with
electrical tape, and make sure the fixture is properly grounded before
reassembling the fixture.
Electronic Ballast Type
Step 5:
Install your new LED tubes in the fixture.
Company Profile
JESLED, devoted to LED lights manufacturing since 2009, focused on providing
environmentally friendly LED products and offer the best price-quality
relation possible.
All of our products comply with international quality standards and are
greatly appreciated in a variety of different markets throughout the world.
Furthermore we attach great importance to our customer experience and value
every constructive feedback from them to improve our products and services.
Today, JESLED offers a wide variety of cost-effective, high quality led
products for every facet of life. We committed to providing each customer with
the highest standard of customer service.
“CUSTOMER FIRST, QUALITY SERVICE” ” SAVE ENERGY, MAKE YOUR LIFE BRIGHTER”
JESLED LIGHTING
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Just Focus. Just Lit.
Email: support@jesled.com
Website: www.jesled.com
24/7 HOURS CUSTOMER SERVICE
Manufacturer: Dong Guan City Shengwei Lighting Co., Ltd
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>