Ottlite CSJ36G5W Capture Clip On LED Ring Light Instructions

CSJ36G5W Capture Clip On LED Ring Light
Instructions

Capture Clip-On LED Ring Light
CSJ36G5W

CSJ36G5W Capture Clip On LED Ring Light

CONGRATULATIONS !
You’ve purchased the finest in natural lighting technology with your new OttLite ® product.

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: www.ottlite.com/warranty
NOTE: THIS UNIT IS FULLY ASSEMBLED

1. Remove lamp from packing.
2. Squeeze clip (A) and securely clip lamp to table, desktop, or other suitable surface.
3. Connect USB power cable (B) to a standard 5V, 2A USB power source such as a computer USB Port or a USB adapter (not included).
4. Verify the lamp is secure before using.
5. Turn the lamp ON/OFF using switch (C) located on cord.
6. To increase the brightness, use the “ + ” button (D). To decrease the brightness, use the “ – ” button (E). The lamp has 10 brightness levels.
7. To change the lamp color mode, press the “Mode” button (F). The lamp has 3 color modes.
8. To position the LED light (G) simply bend the flexneck (H) as needed to point the light, while holding the clip (A) ensuring clip does not come loose while adjusting. NOTE: To avoid damaging the lamp, DO NOT force flex-neck into a sharp bend.

SAFETY WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

1. Turn lamp off and WAIT UNTIL LAMP HEAD COOLS before handling.
2. The LED panel (G) might get hot after several hours of continuous use, DO NOT place your hands directly on LED light panel.
3. Never use with an extension cord unless the USB adapter (not included) can be fully inserted into the receptacles in the extension cord.
4. Do not alter the USB power cable.
5. The lamp head included with this unit cannot be replaced by the consumer.
6. INDOOR USE ONLY.

NOTE: The important safety instructions appearing in this instruction sheet are not meant to cover all possible conditions and situations that may occur.
It must be understood that common sense, caution, and care must be used with any electrical product.
CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE  MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD. INDOOR USE ONLY.

CAUTION! THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE  WHOLE LUMINAIRE SHALL BE REPLACED.

FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to  provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation

CAUTION! Any change or modification to product not expressly recognized by OttLite Technologies voids OttLite’s responsibility for proper function of product.
CAN ICES-005 (B)/NMB-005 (B)

SPECIFICATIONS:

USB: 5V, 2A / Input power: 5V, 2A

INS-22-0692
REV033022

Documents / Resources

| Ottlite CSJ36G5W Capture Clip On LED Ring Light [pdf] Instructions
CSJ36G5W, Capture Clip On LED Ring Light, CSJ36G5W Capture Clip On LED Ring Light, Clip On LED Ring Light, Ring Light, Light
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>