OXSG1P Wireless Surround Transmitter User Manual

**OXSG1P Wireless Surround Transmitter User Manual

**

What’s inside

OXS Satellite Neck Speaker ZH｜OXS| USB A Dongle ZH｜USB A| USB C to C Cable ZH｜USB A
---|---|---

RGB Indicators

| White Pulsing Slow| Not connected
---|---|---
| White Flashing Quick| Enter pairing mode, waiting for connection
| Solid White| Connected
| Red Pulsing| Low battery
| Solid Red| Battery charing
| Red LED Out| Charging Complete
| On 1s, Off 5s| Standby mode

Connection

1. Plug the USB-A dongle on the back of your OXS Thunder Bar.

2. Power on the OXS Satellite Neck speaker.

3. Press and hold the LINK button on the back of your OXS Thunder Bar.

4. Press and hold the LINK button on the OXS Satellite Neck speaker.

5. The display screen will show LINKED, while there will be solid white on the
   LINK button indicating the solid connection.
   Please be noted, the satellite neck speaker will only have sound output under FPS, RAC and MOBA mode.
   Adjusting the Volume
   You can adjust the volume on the OXS Satellite Neck speaker in the menu of the OXS Thunder Bar.

6. Press the settings button on the remote of the OXS Thunder Bar.

7. Press > to navigate the menu to REAR.

8. Press VOL+ or VOL- to adjust the volume of the OXS Satellite Neck speaker.
   Charge
   You can charge the OXS Satellite Neck speaker using the included USB-C to A cable.

Auto Standby
When the soundbar enters standby mode, the satellite neck speaker automatically follows suit. If the soundbar powers on, the neck speaker will reactivate as well.
Note: the neck speaker will automatically turn off after 3 days in standby to conserve energy.

12hrs

Compliance

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• * Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help
  • Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
   This device contains licence-exempt transmitter(s)/receiver(s) that comply with
   Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

2. This device may not cause interference.

3. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>