MOZA RACING HBP Handbrake User Manual
- June 9, 2024
- MOZA RACING
Table of Contents
MOZA Hand Brake
User manual
Product Introduction
- Aviation-grade Aluminum
- Two Modes
- Adjustable Height & Angle
- Direct connection to PC
- Easy to Fix
- 16-bit High Precision Angle Sensor
- Adaptable Brake Force & Travel
Unscrew the nuts with two open-end wrenches counterclockwise, adjust the lever’s height and angle, and then tighten the screws. (It’s recommended to apply the flat and spring pads supplied in the tool kit to avoid scratches.)
Spring Replacement
- Remove the cover above the spring with a Phillips screwdriver
- Remove the baffles on both sides with an Allen wrench
- Pull the handbrake lever until the spring and the baffles tilt
- Remove the screws with a flat-head screwdriver and install the spring
- Adjust the baffle, put the cover back in place, and tighten all screws
Configuration in MOZA Pit House
- Set the start and end points to adjust handbrake travel and eliminate the dead zone.
- Adjust the output curve to change the correlation between mechanical travel and signal output at the initial and final stages.
- Click the calibration button and follow the instructions to re-calibrate if you experience any handbrake output abnormalities.
- Two mode options: on/off button mode or axis mode with continuous brake travel.
Package Content
- Handbrake base
- Handbrake lever
- 1 * Philips screwdriver
- 1 * Flathead screwdriver
- 1 * Spring (blue color)
- 2 * Hex screws
- 2 * data cables (USB-b, RJ45)
- 2 * hex screws (come with flat pads, spring pads, and nuts)
- 2 * umbrella head screws (come with flat pads)
- 3* Allen wrenches
- 1*Damper
- 2*Damper spacers
Product Parameters
- Material: Aluminum
- Dimension: 153 68.3
- 365.5mm
- Adjustable resistance: supported
- Horizontal lever mount: supported
- Side-mount: optional
- Bolt pattern: M6
- Net weight: 0.7 KG
https://support.mozaracing.com/en/support/solutions/70000321076
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>