MEYER CROSS FL1410 Bay 63 .5 in. Blackened Bronze Floor Lamp Instructions
- June 2, 2024
- MEYER CROSS
Table of Contents
FLOOR LAMP
Save these instructions
Instructions
IMPORTANT SAFETY INSTRUCTIONS:
-
These instructions are provided for your safety.
Please read carefully and completely before beginning the assembly and installation of this lighting fixture. -
This lighting fixture is intended for indoor use only.
-
Always place lighting fixture on a solid, level surface.
-
For use with E26 (medium) base light bulbs only.
-
To avoid the risk of fire, do not exceed the maximum wattage of 60W incandescent bulb , or 9W LED bulb , or 23W fluorescent (CFL) bulb , or 9W self-ballasted LED bulb .
(Bulbs not included) -
This lighting fixture has a polarized plug (one prong is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way.
If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted.
Do not alter the plug. Do not attempt to bypass this safety feature.
WARNINGS:
- To reduce the risk of fire, electrical shock, or personal injury: always turn off and unplug this lighting fixture and allow it to cool before attempting to replace the light bulb.
- Do not touch light bulb while fixture is turned on.
- Keep flammable materials away from this lighting fixture.
- Never look directly at a lit bulb.
CARE INSTRUCTIONS:
- Unplug lamp before cleaning.
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective
plastic packaging.
Do not discard any contents until after assembly is complete to avoid
accidentally discarding small parts or hardware.
- Part H (Securing Nuts) may come pre-installed to Part J (Lampshade). Unscrew Part H before installing Part J, then reinstall Part H to secure.
Carefully pull the power cord out from the Base (D) to remove slack.
PARTS INCLUDED:
(A) Top Post
(B) Middle Post
(C) Bottom Post
(D) Base
(E) Washer
(F) Locking Washer| (G) Nut
(H*) Securing Nuts
(J) Lampshade
(K) Wrench
(L) On/Off Foot Switch
---|---
For use with light bulbs with a E26 (medium) base.
Pictured with:
ST19 / ST64 LED
E26 (medium) base (Not included)
DO NOT EXCEED THE SPECIFIED WATTAGE.
BEGIN ASSEMBLY AT THE TOP, AT PART A, AND WORK DOWN.
BE CAREFUL NOT TO STRIP THREADS.
INSTALL LAMPSHADE LAST.
After assembly is completed, loosen and retighten Nut (G) to straighten lamp
if necessary.
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>