Meyer Cross BC1742 Lovett 33 Inch Blackened Bronze Rectangular Bar Cart Instruction Manual
- October 30, 2023
- MEYER CROSS
Table of Contents
Meyer Cross BC1742 Lovett 33 Inch Blackened Bronze Rectangular Bar Cart
Instruction Manual
PRE-ASSEMBLY
Two people are recommended to assemble this furniture.
Carefully remove all parts and hardware from carton, along with any protective
packaging.
Locate and set aside the hardware kit before discarding packaging.
Do not discard any contents until after assembly is complete to avoid
accidentally discarding small parts or hardware.
Assemble the furniture on a soft surface, and take extra care not to scratch
or damage parts during the assembly
Save these instructions
Made in China
PRECAUTIONS — READ ALL BEFORE BEGINNING ASSEMBLY
Do not place items on the shelf which exceed the maximum weight limits of:
- Top shelf: 40 lbs. (18.1 kg)
- Middle Shelves: 20 lbs. (9.07 kg) each
- Lower shelf: 40 lbs. (18.1 kg)
Usage with loads heavier than the maximum weights specified may result in instability, causing tip-over and resulting in death or serious injury.
When in use, this furniture must be placed on a flat, solid and level surface.
Do not climb or step on the shelves.
Remove ALL items from the furniture before attempting to move the furniture.
Do not use a drill or power tools to assemble this furniture, as it may weaken or damage parts
| Part | Description | Quantity |
|---|---|---|
| A | 1 | |
| B | 2 | |
| C | 1 | |
| D | 1 | |
| E | 1 | |
| F | 1 | |
| G | 2 | |
| H | 1 | |
| J | 2 | |
| 1 | ||
| 1/4″ x 12mm | 28 | |
| 2 | ||
| 8 x 2mm | 14 | |
| 3 | 1 |
Assembly Instructions
Two people are recommended to assemble this furniture.
Do not yet fully tighten screws.
Do not FULLY tighten the screws until the glass shelves are installed, and you are sure the glass shelf fits flush with the frame. Once all parts are properly installed and fit together securely, then tighten all screws fully. Do not overtighten screws. Once the glass shelves are in place, DO NOT TILT!
With the help of an assistant, turn bar cart upright.
Once all parts are properly installed and fit together securely, then tighten all screws fully.
CARE INSTRUCTIONS
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the table’s finish.
- Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if necessary