MEYER CROSS FL1595 Blackened Bronze Lamp Instruction Manual
- June 3, 2024
- MEYER CROSS
Table of Contents
MEYER CROSS FL1595 Blackened Bronze Lamp
IMPORTANT SAFETY INSTRUCTIONS
-
These instructions are provided for your safety.
Please read carefully and completely before beginning the assembly and installation of this lighting fixture. -
This lighting fixture is intended for indoor use only.
-
Always place lighting fixture on a solid, level surface.
-
For use with E26 (medium) base light bulbs only.
-
To avoid the risk of fire, do not exceed the maximum wattage of 100W incandescent bulb , or 9W LED bulb , or 23W fluorescent (CFL) bulb , or 9W self-ballasted LED bulb .(Bulbs not included)
-
This lighting fixture has a polarized plug (one prong is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted.
Do not alter the plug. Do not attempt to bypass this safety feature.
WARNINGS:
- To reduce the risk of fire, electrical shock, or personal injury: always turn off and unplug this lighting fixture and allow it to cool before attempting to replace the light bulb.
- Do not touch light bulb while fixture is turned on.
- Keep flammable materials away from this lighting fixture.
- Never look directly at a lit bulb.
CARE INSTRUCTIONS:
- Unplug lamp before cleaning.
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
PRE-ASSEMBLY
Carefully remove all parts and hardware from carton, along with any protective
plastic packaging. The lampshade may be covered with a plastic film that
should be removed
before use. Do not discard any contents until after assembly is complete to
avoid accidentally discarding small parts or hardware.
- Part A (Lampshade Ring) may come pre-installed to Part D (Swing Arm Post/Socket). Unscrew Part A before installing Part B (Lampshade), then reinstall Part A to secure.
PARTS INCLUDED
- (A*) Lampshade Ring
- (B) Lampshade
- (C) On/Off Switch
- (D) Swing Arm Post/Socket
- (E) Top Post
- (F) Middle Post
- (G) Bottom Post
- (H) Base
- (J) Large Washer
- (K) Small Washer
- (L) Tool
For use with light bulbs with a E26 (medium) base.
DO NOT EXCEED THE SPECIFIED WATTAGE.
- BEGIN ASSEMBLY AT THE TOP ON A SOLID, FLAT SURFACE. BE CAREFUL NOT TO STRIP THREADS. INSTALL LAMPSHADE LAST.
After assembly is completed, loosen and retighten Nut (K) to straighten lamp if necessary.