AENO SC1 Cordless Vacuum Cleaner User Manual

AENO SC1 Cordless Vacuum Cleaner

G AENO Vertical Vacuum Cleaner is a household appliance designed to clean dust and small rubbish from all types of household surfaces. Model: ASC0001 (Plug Type C), ASC0001-UK (Plug Type G).

Specifications

• Power adapter input voltage: 100–240 V AC, 50/60 Hz.
• Power adapter output voltage: 26.5 V DC.
• Nominal battery voltage: 21.6 V DC.
• Power: 120.0 W.
• Battery: li-ion.
• Battery capacity: 2200 mAh.
• Charging time: 4 hours.
• Net weight: 1.5 kg.
• Thrust power: max 15 kPa (high power).
• Noise level: min 65 dB.
• Operating time: up to 25 minutes (in turbo mode), up to 45 minutes (in normal mode).
• Dimensions: 1060×230×218 mm.

Package Contents

See Figures a, b and d: 1 extension tube lock,  2 extension tube, 3 main brush lock,  4 battery pack,  5 dustbin housing,  6 main brush,  7 3M tape,  8 power adapter,  9 round brush,  10 crevice brush, 11 screw (3 pcs),  12 mounting panel,  13 plastic dowels,  14 quick start guide,  15 warranty card,  16 removable battery.

Limitations and Warnings

WARNING! The battery can only be charged using the original power adapter. Use of a non-original power adapter (charger) voids the manufacturer’s warranty. Do not use the charger to power or recharge any and all incompatible devices. The manufacturer is not liable for any consequences caused by the use of the power adapter for purposes other than its intended use or for powering or recharging a device not included in the scope of delivery. Make sure the cleaner is disconnected from the power adapter before performing maintenance. Do not immerse the cleaner or any part of it in water or any other liquid. Do not use aggressive or easily flammable detergents to care for the vacuum cleaner. Clean the vacuum cleaner filter regularly. Disconnect the power adapter after fully charging. Do not install the wall
bracket in locations exposed to direct sunlight or excessive heat. Do not use the power adapter if the plug or cord is damaged. Do not attempt to vacuum flammable objects (cigarette butts, matches, ashes) or excessively crushed construction debris (e.g., lime, cement, plaster powder), large sharp objects and fragments (e.g., glass, nails, needles), aggressive liquids (solvent, cleaner, acids), flammable or explosive liquids (e.g., gasoline, alcoholic products). Keep hair, loose clothing, fingers and other body parts away from the air duct and moving parts of the cleaner. Do not point vacuum cleaner air tube, handle or other tools at eyes, ears or other sensitive areas of the body. Carefully examine the area to be cleaned before turning on the vacuum cleaner. If it contains large pieces or lumps of paper, plastic or cloth, sharp objects, or objects larger than the diameter of the vacuum cleaner tube, remove them from the cleaning area beforehand. Otherwise, the tube of the vacuum cleaner may get clogged, which will decrease its suction power. If the cleaner gets too hot, you hear an abnormal sound, the suction power has decreased, or there is an unpleasant odor, stop using it immediately. Inspect the dust container regularly. If there is a lot of rubbish and dust in it, clean it out.

Assembly and Operation

• Attach the battery pack  4 to the dustbin housing  5 (See picture c). Attach the power adapter 8 to the battery pack  16. Plug the power adapter into a power outlet (See figure d). The battery LED will light up red until fully charged (from 4 to 5 hours). When fully charged, the light will turn blue.
  NOTE. You can remove the battery from the battery pack by pressing the button 25.

• When fully charged, disconnect the power adapter from the battery pack and attach the metal extension tube to the dustbin housing 2 (See picture a). To the other end of the metal extension tube attach one of the brushes of the kit:  6 , 9 or 10. You can also attach the brushes directly to the dustbin housing (without the metal extension tube).

• To turn the cleaner on or off, press  22 the switch on the handle of the battery pack. Use the  21 button on the handle of the battery pack to change the vacuum cleaner’s operating mode when the device is already on.

• The vacuum cleaner operates in two modes: normal mode and turbo mode.

• The modes are switched one by one with a button.

Table of vacuum cleaner operation modes

The battery is charged, but the vacuum cleaner motor

does not run

| Press the switch  22| The vacuum cleaner turns on and operates in

normal mode

The vacuum cleaner

operates in normal mode

| Click 21| The vacuum cleaner

operates in turbo mode

The vacuum cleaner operates in turbo mode| Click 21| The vacuum cleaner

operates in normal mode

The vacuum cleaner operates in one of two

modes

| Press the switch 22| The vacuum cleaner turns off

• Before cleaning the dustbin housing, disconnect the battery pack by pressing the rectangular button  23 (see figure c). The bottom lid of the dustbin is opened by pressing the latch 24. You can also remove the MIF filter from the housing  19 and rinse it with water. To do this, unscrew the top part of the dustbin housing  17 counterclockwise (see picture e). Pull out the MIF filter with its holder  20 by pulling the loop labeled “UP”. Clean rubbish from the dustbin housing, holder and MIF filter. Rinse the MIF filter and its holder in running water and dry. After that, insert the MIF-filter into the holder, insert the holder into the body of the dustbin housing and screw the cap.
• The main brush  6 and the roller inside it require regular cleaning of trapped hair and other rubbish. To remove rubish, remove the roller from the brush housing. To do this, pull out the brush lock located on the right side. Push back the brush retainer latch and pull the roller out of the slot. Do not clean the roller with your fingers, use only special brush. Do not wash the roller with water or cleaning detergents.

Troubleshooting

• The vacuum cleaner does not turn on. Possible causes: low charge level, clogging.
  Solution: charge the battery, clean the clogs.

• Weak suction power. Possible causes: overfilled dustbin, clogged brush.
  Solution: clean the dustbin, filters and the brush.

• Strong noise, extraneous sounds. Possible causes: clogged metal extension tube.
  Solution: clean the tube.

• The main brush roll does not rotate. Possible causes: clogging.
  Solution: disassemble the main brush, remove the roller and the clog.

• The LED indicator lights up blue, then it starts blinking red and the cleaner shuts off. Possible causes: the battery has overheated or overcooled because the room temperature is too high or too low.
  Solution: use the vacuum cleaner at temperatures between 0 °C and +40 °C.

• While charging, the LED indicator lights up red. Possible causes: non-original power adapter is used, the battery is out of order.
  Solution: Use only the original power adapter to charge the vacuum cleaner.

ATTENTION! If your problem persists, please contact your local supplier or the service center for support. Please do not disassemble the device or try to repair it on your own.

DISPOSAL

• These symbols indicate that you must follow the Waste Electrical and Electronic Equipment (WEEE) and Waste Battery and Battery Regulations when disposing of the device, its batteries and accumulators, and its electrical and electronic accessories.
• According to the rules, this equipment must be disposed of separately at the end of its service life. Do not dispose of the device, its batteries and accumulators, or its electrical and electronic accessories together with unsorted municipal waste, as this will harm the environment. To dispose of this equipment, it must be returned to the point of sale or turned in to a local recycling facility. You should contact your local household waste disposal service for details.
• ASBISc reserves the right to modify the device and to make edits and changes to this document without prior notice to users.
• The warranty period and service life shall be 2 years as from the date of purchase of the device. Information about the manufacturer: ASBISc Enterprises PLC, Iapetou, 1, Agios Athanasios, 4101, Limassol, Cyprus. Made in China.
• For current information and details on the device description and specification, as well as connection process, certificates, warranty and quality issues, see relevant Installation and Operation Manuals available for downloading at aeno.com/documents. All trademarks and names herein are the property of their respective owners.

References

• Documents | AENO in Europe

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>