AENO AVS0002-UK Vacuum Sealer User Guide
- October 30, 2023
- AENO
Table of Contents
Vacuum Sealer VS2, V52-UK
(Models: AVS0002, AVS0002-UK)
19.04.2023 | v.1.1.1
Quick Start Guide
AVS0002-UK Vacuum Sealer
The AENO vacuum sealer is designed for vacuum packaging of foodstuffs in
order to extend their shelf life, for pickling or sous vide cooking.
Model: AVS0002 (Plug Type C), AVS0002-UK (Plug Type G).
Specifications
Voltage: 220 V; Frequency: 50 Hz. Power: 120.0 W. Capacity: up to 4.5 L/min.
Vacuum degree: –75 kPa. Vacuum sealing time: up to 20 sec. Single heat seal:
up to 13 sec. Heating wire width: 2 mm. Bag width sealable: up to 30 cm.
Maximum heating temperature: up to +200 °C. Modes: “Dry”, “Moist”. Control:
automatic, pulse (manual). Dimensions (L×W×H): 375×150×70 mm.
Scope of delivery (figure a)
Vacuum sealer AENO, vacuum bags (15×20 cm (5 pcs), 20×30 cm (5 pcs)), adapter
(vacuum hose) for vacuuming containers, quick start guide, warranty card.
Limitations and Warnings
- Please read this document carefully before using the unit. The complete manual is available for download at aeno.com/documents.
- Before powering on for the first time, make sure that the power supply corresponds to the connection parameters of the device (frequency and voltage) from the technical specifications section.
- Do not use the device if the power cord and/or plug is damaged. The unit should be repaired by a qualified technician.
- Do not immerse the device, power cord and/or plug in water or other liquids. Do not install the unit on wet or hot surfaces or near external heat sources.
- To avoid getting burned, do not touch the welding strip (9) and the weld after soldering until they have cooled down.
- After each use of the vacuum sealer, especially if plastic particles from the bag are left on the welding bar, it is necessary to clean it. Unplug the unit by removing the power cord plug from the outlet and allow to cool. Wipe the surface of the device with a soft cloth soaked in warm water or a weak soap solution. Then wipe with a soft cloth soaked in clean water and wipe dry. Do not use harsh detergents, abrasive pastes, polishes or detergents containing acids or solvents.
- Use “Moist” mode only for products with a small amount of liquid.
- Do not vacuum liquid food, it is only suitable for sealing.
- Use only special bags for vacuum sealers.
- The adapter (vacuum hose) supplied with the vacuum sealer is only used to evacuate air from special vacuum containers.
- It is recommended to dry wet foods with a clean towel or cloth before vacuuming.
- Before putting vacuum-packed foods into microwave, make a hole in the package or open the outlet valve in the container to release steam.
- Use only manufacturer-recommended accessories, consumables and/or replacement parts. For more information see the full manual available for download at aeno.com/documents.
- After use the device should be left to cool down.
- During storage in order not to deform the seal (12) and thus not to impair the performance of the device, it is recommended to close the cover loosely without locking the locks (8).
- Do not allow children to use and/or play with the device.
Device control
Automatic vacuuming and/or sealing of packages
- Connect the device to a power source by connecting the power cord to the device and then plugging the power cord into a power outlet.
- Place the food in a vacuum bag. Gently secure the open edge of the bag with bag clips (7) (see Fig. b).
- Press lightly on both sides of the cover. After a characteristic click both fasteners (8) will close automatically.
- Select Mode. To switch between modes, press the “Dry/Moist” button (1) on the device body. The “Dry” mode corresponds to the blue indicator (6) on the control panel and the “Moist” mode corresponds to the red one.
- Press the “Vac Seal” button (3) on the unit to start the vacuuming and sealing process or the “Seal” button (4) to start the sealing process only.
- When sealing is complete, the light on the control panel will turn off and then after a few seconds it will start blinking again.
- Press the buttons (15) on the device at the same time, the cover will open automatically.
- Remove the bag.
Vacuuming and sealing soft products
For working with soft and delicate products it is recommended to choose the
manual (pulse) control. This type of control allows you to control the
intensity of air pumping so as not to spoil the appearance of the products.
To do this instead of steps 4 and 5 of the “Automatic Vacuuming and/or Sealing
of Bags” section, press and hold the “Pulse” button (2) until the vacuuming
level you want is reached, while maintaining the shape of the bag contents and
then press the “Seal” button (4) to seal the bag.
Vacuum packing in containers
- Put the food into vacuum container and close the lid.
- Connect the container outlet valve (13) and the air extraction hole (10) on the vacuum sealer with vacuum hose (14) (see fig. c).
- Make sure that there is no air leakage between the lid and the container.
- Press the canister button (11) on the device to start the vacuum process.
- When the air has been vacuumed press again the button (11) on the device body, disconnect the adapter and close the container outlet valve.
Interrupting the vacuuming and/or sealing process
Press the “Stop” button (5) to stop all the operations.
Note. At least 30 sec must elapse before the next start of the vacuum
packer to prevent the heating element from overheating.
Recommendations on the shelf life of vacuum-packed food Cold storage (+5 °C
+/– 3 °C):
- raw meat – up to 8–9 days;
- fish and seafood – up to 4–5 days;
- sausages – up to 10–14 days;
- vegetable – up to 7–10 days;
- fruit – up to 14–20 days;
- egg – up to 30–50 days.
Freeze storage (-16 °C to -20 °C):
- meat, fish, seafood – up to 1 year.
Indoor temperature (+25 °C +/- 2 °C):
- bread – up to 6–8 days;
- biscuit, cereals/flour, nuts, dried fruit, tea – up to 1 year.
Note. A complete list of products and storage times is available in the complete user manual at aeno.com/documents.
Troubleshooting
- There were traces of a package on the welding strip. Possible cause: overheating of the welding strip. Solution: Allow the device to cool for 90 sec.
- After sealing air appears in the bag. Possible cause: piercing the bag with sharp petioles, fish bones, pasta, etc. Solution: replace the bag, remove the protruding sharp parts.
- The sealing seam is not strong. Possible reason: insufficient sealing time. Solution: Repeat the sealing process.
ATTENTION! If your problem persists, please contact your local supplier
or the service center for support. Please do not disassemble the device or try
to repair it on your own.
**** These symbols indicate that you must follow the Waste Electrical and
Electronic Equipment (WEEE) and Waste Battery and Battery Regulations when
disposing of the device, its batteries and accumulators, and its electrical
and electronic accessories. According to the rules, this equipment must be
disposed of separately at the end of its service life. Do not dispose of the
device, its batteries and accumulators, or its electrical and electronic
accessories together with unsorted municipal waste, as this will harm the
environment. To dispose of this equipment, it must be returned to the point of
sale or turned in to a local recycling facility. You should contact your local
household waste disposal service for details.
ASBISc reserves the right to modify the device and to make edits and changes
to this document without prior notice to users.
The warranty period and service life is 2 years from the date of purchase of
the product.
Information about the manufacturer: ASBISc Enterprises PLC, Iapetou, 1, Agios
Athanasios, 4101, Limassol, Cyprus. Made in China.
For current information and details on the device description and
specification, as well as connection process, certificates, warranty and
quality issues, see relevant Installation and Operation Manuals available for
downloading at aeno.com/documents. All trademarks
and names herein are the property of their respective owners.
aeno.com/documents
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>