SKYMEE AI-B20 Smart Feeder User Manual

Table of Contents

SKYMEE AI-B20 Smart Feeder User Manual

Product Overview

Make sure that the position of the feeder is not moved any more, and use double-sided adhesive tape to fix it

5M 3M 3M
M3M 3M 3M
3M 3M 3M 3M

Role of the protective cover

Prevent the pet from biting the discharging door
Prevent the infrared detection of the equipment from being disturbed by infrared light in sunlight or strong light.

Put the food in correct direction and close surface cover
Product Overview

Turn it to left by 90°

Align the mounting mark location

33 stable foot pedestals at the bottom of the main engine. to replace non-slip MATS (optional installation)

Install the protective cover corresponding to the position of screw hole and turn the screw by hand

Install the food bowl and turn the screws by hand

Assembly Instruction

Open the cover of the grain bin and lift the fixed needle column in the grain bin by hand
When the fixed needle column is lifted up, the grain bin can be removed by rotating the grain bin 90° to the left while the main engine is stablized

Powered by external power supply

Red light: Slowly flashing for no food or device fault Quick flashing for no food
Blue light: Slowly flashing for configurable state
Quickly flashing for networking Normally on for successful connection
Blue light on for 15s: Powered on and starting
Powered by built-in battery
Red light: Normally on for normal power supply by battery Flashing for food clogging, device fault, battery low

Attentions

Minimum requirements for equipment use
Equipment end web requirement
In case of standard resolution, the uplink bandwidth speed is at least 512kbps.
In case of high resolution, the uplink bandwidth speed is at least 1Mkbps.
app end web:
The uplink bandwidth speed is at least 512kbps for standard resolution and at least 1Mkbps for high resolution.
Please do not allow anything other than pet food to fall into the material pail, otherwise the equipment will become abnormal for operation or even a pet safety problem may arise. The dog food diameter is ≤15MM. 3.Do not allow pets to bite the electric wire, which may lead to death due to electric shock.
Please ensure that any child uses this equipment under the guide of an adult.
Do not touch the food outlet in food discharging.

If connection fails when hearing “Doo” in reading the 2D code for adding equipment, check if the Wi-Fi password is connect and connect again, or change to equipment hot point for equipment addition. (See if the equipment indicator lamp is Blue and blinks. If the Blue lamp is on constantly, press and hold the equipment Reset hole. On hearing “Doo” after 5 seconds, have the equipment resume to the addition state).
In case of failing to read the 2D code and hear “Doo” in adding equipment, check if the equipment indicator lamp is Blue and blinks. If the Blue lamp is on constantly, it indicates that there has been an equipment addition, You can press and hold the equipment Reset hole, On hearing “Doo” after 5 seconds, have the equipment resume to the addition state. Just connect again.
In case of any error in equipment addition, you may have used 5G Wi-Fi for binding. Wireless Wi-Fi supports 2.4GHz frequency band only. 5G Wi-Fi is not supported temporarily. Please adjust for 2.4G Wi-Fi.
The real-time pictures are not smooth, Confirm if the web uploading and downloading rates meet the equipment work requirements. If the web rate is too low, you may choose a smooth mode.
The equipment displays offline. Check if the web is normal.
That the equipment red lamp is on indicates that there is no food or the equipment is abnormal.
When the equipment does not work or the power is not supplied normally, check if the rated working voltage is 5V and the rated power 10W/2000mA.