Ford Engine 3.5L Ti-VCT Crankshaft Pulley Instruction Manual
- June 4, 2024
- Ford
Table of Contents
Ford Engine 3.5L Ti-VCT Crankshaft Pulley
Report a problem with this article
| 303-01B Engine — 3.5L Ti-VCT| 2014
Explorer
---|---|---
REMOVAL AND INSTALLATION| Procedure revision date: 08/11/2015
Special Tool(s)
| **** | Installer, Front Cover Oil Seal 303-335T88T-6701-A |
|---|---|
| **** | Installer, Crankshaft |
VibrationDamper
303-102T74P-6316-B
****| Strap Wrench
303-D055D85L-6000-A
General Equipment
Three Leg Puller
Material
| Item | Specification |
|---|
Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil (US); Motorcraft® SAE 5W-20 Super Premium Motor Oil (Canada)
XO-5W20-QSP (US); CXO-5W20-LSP12 (Canada)
| WSS- M2C945-A
Removal
WARNING:
Before beginning any service procedure in this section, refer to Safety
Warnings in Section
100- 00. Failure to follow this instruction may result in serious personal injury.
- With the vehicle in NEUTRAL, position it on a hoist. REFER to Section 100-02, Jacking and Lifting, Lifting Points.
- Remove the RH splash shield. REFER to Section 501-02, Fender Splash Shield.
- Remove the accessory drive belt. REFER to Section 303-05, Accessory Drive Belt – 3.5L Ti-VCT, 3.7L Ti-VCT.
- Remove the crankshaft pulley bolt and washer.
- Discard the bolt.
- NOTE: Use a three-leg puller (such as Matco Tools® MST9740D, or equivalent). Using a three-leg puller, remove the crankshaft pulley.
Installation
- Lubricate the crankshaft front seal inner lip and crankshaft pulley outside diameter sealing surfaces with clean engine oil.
- Using 303-102 T74P-6316-B and 303-335 T88T-6701-A , install the crankshaft pulley.
- Using strap wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.
- Install the accessory drive belt. REFER to Section 303-05, Accessory Drive Belt – 3.5L Ti-VCT, 3.7L Ti-VCT.
- Install the RH splash shield. REFER to Section 501-02, Fender Splash Shield.
- After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
Copyright © 2018 Ford Motor Company.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>