Mercury Netcomm NF4V Fibre WiFi Gigabit Modem Router User Manual

Mercury Netcomm NF4V Fibre WiFi Gigabit Modem Router

Using your own router? No worries, we’ve got you covered!

Log into the gateway

1. Ensure your device is connected to the Router (preferably via cable)
2. Open a web browser
3. Type the following in the address bar at the top: 192.168.20.1
4. Default Username: admin
5. Default Password: password

This should then give access to the router’s user interface
(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds).

How to add correct settings for the Mercury network

1. From the menu on the left select: Advanced Setup
2. From the sub-menu select: WAN Service

In the page Select the Remove tickbox for all connections:

1. Select: Remove
2. Select: Add

Ensure the following settings are changed:

1. Wan Service Int Config: ETH4/ETH4
2. Select: Next
3. WAN Service Type: PPP over Ethernet (PPPoE)
4. Service Decription: (left as is)
5. 802.1P Priority: 0
6. 802.1Q VLAN ID: 10
7. Select: Next
8. PPP Username: (your mercury acct number)@mercurybroadband.co.nz
9. PPP Password: password
10. PPPoE Service Name: Mercury
11. All other settings can be left as is
12. Select: Next
13. Leave this page as is
14. Select: Next
15. Select anything in the right box and move to left box
16. Select: Next
17. Select: Apply/Save

You should now be connected to Fibre!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>