MERCURY 6220 Wireless Dual-Band Router Instructions

MERCURY 6220 Wireless Dual-Band Router

Using your own router? No worries, we’ve got you covered!
Log into the gateway:

1. Connect your device to the router (preferably hardwired)
2. Open a Web Browser
3. In the web browsers address bar type: www.routerlogin.net
4. Default Username: admin
5. Default Password: password or Admin (this may have been changed to your own)

This should then give access to the router’s user interface (If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds.

How to add correct settings for the Mercury network:
How to change the correct settings:

1. From the Advanced menu select: Setup
2. From the sub-menu select: WAN Setup
3. WAN Preference: Must Use Ethernet WAN

This will now reboot the router

1. From the Advanced tab select Setup
2. From the sub-menu select: Internet Setup
3. Select Country: NZ
4. Select Internet Service Provider: Other
5. Enable This Interface: Ticked
6. Use VLAN ID: Ticked – 10
7. Does your internet require a login: Yes
8. Internet Service Provider: PPPoE
9. Login: ((your mercury acct number)@mercurybroadband.co.NZ
10. Password: password
11. Connection Mode: Always On
12. Click: Apply (top of page)This will again reboot the router

You should now be connected to Fibre!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>