MW APV-16 series 16W Single Output Switching Power Supply Instruction Manual
- June 3, 2024
- MW
Table of Contents
MW APV-16 series 16W Single Output Switching Power Supply
Features
- Constant voltage design
- Universal AC input/ Full range
- Protections: Short circuit/ Over load/ Over voltage
- Fully isolated plastic case
- Cooling by free air convection
- Small and compact size
- Class II power unit, no FG
- Class 2 power unit
- Pass LPS
- IP42 design
- Suitable for LED-related fixtures or appliance
- (Such as LED Decoration or Advertisement devices)
- 100% full load burn-in test
- Low cost, high reliability
- 2 years warranty
SPECIFICATION
NOTE
-
All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25C of ambient temperature.
-
Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
-
Tolerance: includes set up tolerance, line regulation and load regulation.
-
Derating may be needed under low input voltage. Please check the static characteristics for more details. Please connect L line to the positive pole and
N line to the negative pole under DC input. -
The power supply is considered as a component that wil be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
-
The length of set up time is measured at first cold start. Turning ONOFF the power supply may lead to an increase of the set up time.
-
This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPFXLG series are recommended.)
-
The model certified for CCC(GB19510.14, GB19510.1, GB17743 and GB17625.1) is an optional model. Please contact MEAN WELL for details.
-
The ambient temperature derating of 3.5 C/1000m with fanless models and of 5 C/1000m with fan models for operating altitude higher than 2000m(6500ft).
-
Products sourced from the Americas regions may not have the ENEC/BIS/CCC logo. Please contact your MEAN WELL sales for more information.
-
For any application note and P waterproof function installation caution, please refer our user manual before using.
https://www.meanwel.com/Upload/PDF/LED_EN.pdf Product Liability Disclaimer For detailed information, please refer to -
https://www.meanwell.com/serviceDisclaimer.aspx
NOTE
File Name: APV.16-SPEC 2022-08-05
Mechanical Specification
Block Diagram
Derating Curve Static Characteristics
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>