MW APC-12E series 12W Single Output Switching Power Supply Instruction Manual
- June 3, 2024
- MW
Table of Contents
MW APC-12E series 12W Single Output Switching Power Supply
Features
- Constant current design
- Protections:Short circuit/ Over voltage
- Fully isolated plastic case
- Small and compact size
- Cooling by free air convection
- Class II power unit, no FG
- No load power consumption <0.5W
- IP42 design
- Suitable for LED lighting and moving sign applications
- 100% full load burn-in test
- Low cost/ High reliability
- 2 years warranty
Description
APC-12E series is one 12W AC/DC constant current mode single output LED power supply. It accepts input 180-264VAC and provides two models with different output current, 350mA and 700mA, respectively, that the small wattage LED applications employ the most frequently. Exploiting Class design (without FG pin) and adopting the 94V-0 flame retardant plastic enclosure, APC-12E ideally fits the entry-level LED applications.
Model Encoding
Applications
- Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices) (Note.7)
GTIN CODE
MW Search : https://www.meanwell.com/serviceGTIN.aspx
12W Single Output Switching Power Supply
SPECIFICATION
| MODEL | APC-12E-350 | APC-12E-700 |
|---|
OUTPUT
| RATED CURRENT| 350mA| 700mA
DC VOLTAGE RANGE| 9~36V| 9~18V
RATED POWER| 12.6W| 12.6W
RIPPLE & NOISE (max.)Note.2| 300mVp-p| 250mVp-p
VOLTAGE TOLERANCE Note.3| ±5.0%
CURRENT ACCURACY| ±8.0%
LINE REGULATION| ±1.0%
LOAD REGULATION| ±3.0%
SETUP, RISE TIME| 500ms, 180ms / 230VAC
HOLD UP TIME (Typ.)| 20ms/230VAC at full load
INPUT
| VOLTAGE RANGE Note.4| 180 ~ 264VAC 254 ~ 370VDC
FREQUENCY RANGE| 47 ~ 63Hz
POWER FACTOR (Typ.)| PF>0.5/230VAC at full load
EFFICIENCY (Typ.)| 81%| 79%
AC CURRENT| 0.2A/230VAC
INRUSH CURRENT (Typ.)| COLD START 70A(twidth=120μs measured at 50%
Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER| 17 units (circuit breaker of
type B) / 29 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT| 0.25mA / 240VAC
PROTECTION| OVER VOLTAGE| 39.6~ 46.8V| 20.7~ 24.3V
Protection type : Shut off o/p voltage, clamping by zener diode
ENVIRONMENT
| WORKING TEMP.| -30 ~ 70℃(Refer to “Derating Curve”)
WORKING HUMIDITY| 20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY| -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT| ±0.2%/℃ (0 ~ 50℃)
VIBRATION| 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X,
Y, Z axes
SAFETY & EMC
(Note 5)
| SAFETY STANDARDS| IP42, BS EN/EN 62368-1 approved
WITHSTAND VOLTAGE| I/P-O/P:3.75KVAC
ISOLATION RESISTANCE| I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION| Compliance to BS EN/EN55032,BS EN/EN61000-3-2,BS
EN/EN61000-3-3
EMC IMMUNITY| Compliance to BS EN/EN55035,BS
EN/EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV)
OTHERS
| MTBF| 6112.3K hrs min. Telcordia SR-332 (Bellcore) ; 1013.6K hrs
min. MIL-HDBK-217F (25℃)
DIMENSION| 774029(LWH)
PACKING| 0.08Kg; 120pcs/11.8Kg/1.06CUFT
NOTE| 1. All parameters NOT specially mentioned are measured at 230VAC
input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristic for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
7. This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.)
8. For any application note and IP water proof function installation caution, please refer our user manual before using. https://[www.meanwell.com/Upload/PDF/LED_EN.pdf](http://www.meanwell.com/Upload/PDF/LED_EN.pdf)
※ Product Liability Disclaimer：For detailed information, please refer to https://[www.meanwell.com/serviceDisclaimer.aspx](http://www.meanwell.com/serviceDisclaimer.aspx)
Mechanical Specification
Block Diagram
Derating Curve
Static Characteristics
Documents / Resources
| MW
APC-12E series 12W Single Output Switching Power
Supply
[pdf] Instruction Manual
APC-12E series, 12W Single Output Switching Power Supply, APC-12E series 12W
Single Output Switching Power Supply, Output Switching Power Supply, Power
Supply
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>