WyreStorm EXP-EX-80-KVM 80m KVM UTP HDMI Extender Over Ethernet User Guide
- June 3, 2024
- WyreStorm
Table of Contents
WyreStorm EXP-EX-80-KVM 80m KVM UTP HDMI Extender Over Ethernet
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the installation process.
**IMPORTANT! Installation Requirements
**
- Visit the product page to download the latest firmware, document version, additional documentation, and configuration tools.
- Read through the Wiring and Connections section for important wiring guidelines before creating or choosing premade cables.
In the Box
- 1x EXP-EX-80-KVM Transmitter
- 1x EXP-EX-80-KVM Receiver
- 1x 12V DC 2A Power Supply (US/UK/EU/AU)
- 1x USB Type B to Type A Cable
- 4x Mounting Brackets
Basic Wiring Diagram
Transmitter (Front/Rear)
Receiver (Front/Rear)
Wiring and Connections
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in it’s entirety before running or terminating the wires to ensure proper operation and to avoid damaging equipment.
IMPORTANT! Wiring Guidelines
- The use of patch panels, wall plates, cable extenders, kinks in cables, and electrical or environmental interference will have an adverse effect on signal transmission which may limit performance. Steps should be taken to minimize or remove these factors completely during installation for best results.
- WyreStorm recommends the use of shielded category cable to minimize signal noise and interference.
- WyreStorm recommends using pre-terminated HDMI cables due to the complexity of these connector types. Using pre-terminated cables will ensure that these connections are accurate and will not interfere with the performance of the product
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
- Verify that power is being supplied to the transmitter and receiving device
- Verify that all HDMI and UTP connections are not loose and are functioning properly
- Verify that the UTP cable is properly terminated following EIA568B standard
- Verify that the output resolution of the source and display is supported by this extender
Failed USB Connection or Slow Transmission rate
Ensure the category cable length is within the range of requirement, USB HID
device is within 80m/260ft, USB storage device is within 60m/200ft.
Troubleshooting Tips:
WyreStorm recommends using a cable tester or connecting the cable to other
devices to verify functionality.
Specifications
Note: WyreStorm reserves the right to change product specification, appearance or dimensions of this product at any time without prior notice
Warranty Information
WyreStorm Technologies LLC warrants that its products to be free from defects in material and workmanship under normal use for a period of two (2) years from the date of purchase. Refer to the Product Warranty page on wyrestorm.com for more details on our limited product warranty.
Copyright © 2020 WyreStorm Technologies | wyrestorm.com EXP-EX-80-KVM Quickstart Guide | 200330 UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) support@wyrestorm.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>