WyreStorm SW-120-TX3-US 2 Input 4K60Hz HDBaseT In Wall Transmitter User Guide
- June 1, 2024
- WyreStorm
Table of Contents
WyreStorm SW-120-TX3-US 2 Input 4K60Hz HDBaseT In Wall Transmitter
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the installation process.
IMPORTANT! Installation Requirements
- Visit the product page to download the latest firmware, document version, additional documentation, and configuration tools.
- Read through the Wiring and Connections section for important wiring guidelines before creating or choosing premade cables.
- While this product supports CEC, WyreStorm cannot guarantee compatibility with all forms of CEC communication.
In the Box
- 1x SW-120-TX3-US/SW-120-TX3-UK In-Wall Transmitter
- 1x 1.8m USB2.0 Type-B to Type-A cable
- 1x 2m USB-C to USB-C Cable with Locking Connector (5Gbps)
- 1x 3-pin Terminal Block
- 1x 2-pin Terminal Block
- 1x Wall Plate (2-gang US) – (US model only)
- 4x Mounting Screws
- 1x Quickstart Guide (This Document)
- *20v 6a PSU Sold Separately
Basic Wiring Diagram
SW-120-TX3-US (Front/Rear)
SW-120-TX3-UK (Front/Rear)
Wiring and Connections
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in it’s entirety before running or terminating the wires to ensure proper operation and to avoid damaging equipment.
IMPORTANT! Wiring Guidelines
- The use of patch panels, wall plates, cable extenders, kinks in cables, and electrical or environmental interference will have an adverse effect on signal transmission which may limit performance. Steps should be taken to minimize or remove these factors completely during installation for best results.
- WyreStorm recommends using pre-terminated HDMI and USB cables due to the complexity of these connector types. Using pre-terminated cables will ensure that these connections are accurate and will not interfere with the performance of the product.
- This product contains a USB-C connection that can be used as an audio/ video input. When using this connection verify that the USB-C cable used supports audio/video functionality as not all USB-C cables support this requirement.
RS-232 Wiring
The SW-120-TX3-Ux uses a 3-pin RS-232 with no hardware flow control. Most
control systems and computers are DTE where pin 2 is RX, this can vary from
device to device. Refer to the documentation for the connected device for pin
functionally to ensure that the correct connections can be made.
- Baud Rate: 115200
- Byte: 8bits
- Pairty: No
- Stop Bit: 1
Note : The RS-232 port is software driven which allows the SW-120-TX3-Ux to distinguish between a self-switching command or whether a routed, device control command is being sent over HDBaseT
Power Wiring
The SW-120-TX3-UX uses a 2-pin Terminal Connector if 60w USB-C device charging
is required (20v 6a PSU not included)
Audio Connections
The audio connections use a 3.5mm (1/8in) TRS Stereo Jack.
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
- Verify that power is being supplied to the transmitter and receiving device.
- Verify that all HDMI, USB and HDBaseT connections are not loose and are functioning properly.
- Verify that the HDBaseT cable is properly terminated following EIA568B standard.
- Verify that the output resolution of the source and display is supported by this extender.
- If transmitting 4K, verify that the HDMI cables used are 4K rated.
No or Intermittent 3rd party Device Control
- Verify that the RS-232 cables are properly terminated following the Wiring and Connections section.
Troubleshooting Tips:
- WyreStorm recommends using a cable tester or connecting the cable to other devices to verify functionality.
Note : WyreStorm reserves the right to change product specification, appearance or dimensions of this product at any time without prior notice.
Warranty Information
WyreStorm Technologies LLC warrants that its products to be free from defects
in material and workmanship under normal use for a period of five (5) years
from the date of purchase. Refer to the Product Warranty page on wyrestorm.com
for more details on our limited product warranty.
Copyright © 2023 WyreStorm ProAV Corporation |
wyrestorm.com
SW-120-TX3-Ux Quickstart Guide | 231101
INT: +44 (0) 1793 230 343 | US: 844.280.WYRE (9973)
support@wyrestorm.com
Documents / Resources
|
WyreStorm SW-120-TX3-US 2 Input 4K60Hz HDBaseT In Wall
Transmitter
[pdf] User Guide
SW-120-TX3-US 2 Input 4K60Hz HDBaseT In Wall Transmitter, SW-120-TX3-US, 2
Input 4K60Hz HDBaseT In Wall Transmitter, 4K60Hz HDBaseT In Wall Transmitter,
HDBaseT In Wall Transmitter, Wall Transmitter, Transmitter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>