LEDISONS Flicker Free Led paneel 60×60 UGR Instructions
- June 3, 2024
- LEDISONS
Table of Contents
LEDISONS Flicker Free Led paneel 60×60 UGR
ELECTRICAL CONNECTION DIAGRAM
First, connect the panel to the driver, then connect the driver to the mains.
(Otherwise, the driver will enter short circuit protection and the panel will
not light up).
INSTALLATION
A. Installation in a suspended ceiling
Remove the ceiling gypsum board.
Connect the power cord.
Put through the panel light along ceiling’s diagonal.
Fix the panel light to suitable place and power on.
B. Spring fastener installation
Fix the four spring fasteners with the screws to the panel light.
Pull the spring fasteners into the vertical position, in order to snap the
panel into the cut hole.
Pull the spring fasteners into their horizontal position in order to secure
the panel.
Connect three frames by using the plastic corners and screw fix this onto the
roof by using the screws.
Slide the panel into the frame until it completely is in its place. Connect
the panel to mains.
Screw the last frame side onto the frame to secure the panel to complete the
installation.
D. Hanging installation
LIGHT-DIMMER: 0-10V DRIVER
| WARNINGS – GUARANTEE
This unit must only be used for the purpose for which it was manufactured. Any
other use is to be considered inappropriate and therefore dangerous.
Contact authorized staff for any repairs and ask the manufacturer for genuine
spare parts.
Failure to comply with these instructions may compromise the safety of the
unit.
If the power cable is damaged, it must be replaced by the manufacturer or
authorized technicians.
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>