AES e-LOOP Mini Wireless Vehicle Detection System Instructions
- June 3, 2024
- AES
Table of Contents
AES e-LOOP Mini Wireless Vehicle Detection System
e-LOOP Mini Fitting Instructions
Before fitting the e-Loop, you will need to fit the 2 x AA batteries and screw the bottom plate to the e-Loop using the M3 screws supplied. Ensure all screws are tight.
Step 1 – Coding e-LOOP Mini
- Press and hold the CODE button on the transceiver until the Red LED illuminates, now release the button.
- Press the CODE button on the e-Loop Mini. The Yellow LED on the e-Loop will flash 3 times to indicate transmission, and the Red LED on the transceiver will flash 3 times to confirm the coding sequence has been completed.
Step 2 – Coding e-LOOP Mini (Refer to Diagram on the right)
- Place e-Loop in the desired location and secure base plate into the ground using 2 Dyna bolts (supplied).
- NOTE: Never fit near high voltage cables, this can affect the e-Loop’s detection capability.
Step 3 – Calibrate e-LOOP Mini
- Move any metal objects away from the e-Loop, including cordless drills.
- Press and hold the CODE button and the Yellow LED will flash once, keep your finger on the button until the Red LED flashes twice.
- Now fit the e-Loop to the base plate using the 4 x Hex Head bolts. After 3 minutes, the Red LED will flash a further 3 times. The e-Loop is now calibrated and ready to use.
The system is now ready.
Uncalibrate e-LOOP Mini
Press and hold the CODE button and the Yellow LED will flash, keep your finger
on the CODE button until you see the Red LED flash 4 times. Now release button
and e-Loop is uncalibrated.
Specifications
- Frequency: 433.39 MHz.
- Security: 128-bit AES encryption.
- Range: up to 50 metres.
- Battery life: up to 3 years.
- Battery type: Eveready AA Lithium 1.5V x 2. Important: Use only AA 1.5V Lithium batteries – do not use Alkaline batteries.
E. sales@aesglobalonline.com
T: +44 (0) 288 639 0 693
www.aesglobalonline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>