Laserliner RollPilot D12 Electronic Measuring Wheel Instructions
- June 4, 2024
- Laserliner
Table of Contents
RollPilot D12
! Read the operating instructions and the enclosed brochure „Guarantee and additional notices“ completely. Follow the instructions they contain. Safely keep these documents for future reference.
Function / application
The electronic distance measuring wheel is designed for use on straight lines and curves. The electronic measuring wheel provides measured distance values exact to the centimeter over distances of up to 9,999.99 m. The moving pointer shows the exact start and end positions. The folding design and transport case make the measuring wheel easy to carry.
- Insert battery Open the battery compartment (6) and insert a 9 V battery. Correct polarity must be observed.
1. LC display
2. Operating buttons
3. Non-slip handle
4. Locking lever
5. Carrier handle| 6. Battery compartment
7. Measuring wheel with 1 m circumference
8. Stand (fold-out)
9. Moving pointer for start and end position
---|---
a Display lighting ON/OFF / Select a memory location
b Memory function
c Hold function ON/OFF
d ON/OFF button
e Unit of measure selection: m/ft
f Delete measured value / Select memory location
g Measured value memory M1-M5| h Unit of measure cm/inch
i Measured value cm/inch
j Unit of measure m/feet
k Measured value m/feet
l Low battery charge
m Hold function symbol
---|---
2. ON/OFF
3. Hold function
The Hold function is active when the Hold symbol appears on the display and
the measured value ashes. The current measured value is held.
!The Hold function must be deactivated in order to start the
measurement.
-
Display lighting
If visibility is poor, switch on the display lighting. In order to preserve the batteries, the lighting switches off automatically after 15 seconds. Simply press the button again to switch the lighting back on.
-
Select unit of measure m (cm) / ft (in)
-
Delete the measured value The current measured value is deleted.
-
Save measured value The device has an internal measured value memory for storing 5 entries. The selected memory location is indicated by M1…M5 ashing.
! Previously saved measured values are overwritten.
! The value M1 is always shown when the memory function is activated. The current measured value appears again as soon as it has been saved to the required location (M1 – M5). -
Show measured values
-
Clear measured value memory
-
Fold for carrying
Technical data Subject to technical alterations.
| Accuracy | ± 10 cm / 100 m |
|---|---|
| Range | 0 – 9,999.99 m |
| Circumference of measuring wheel | 1 m |
| Measured value memory | 5 entries M1 … M5 |
| Power supply | 1 x 6F22 / 9V |
| Operating temperature | 0…40 °C |
| Storage temperature | -20 °C…70 °C |
| Dimensions (W x H x D) | 318 x 1000 x 140 mm / 318 x 540 x 210 mm (folded) |
| Weight (including batteries) | 2,1 kg |
EU directives and disposal
This device complies with all necessary standards for the free movement of
goods within the EU.
This product is an electric device and must be collected separately for
disposal according to the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
SERVICE
Umarex GmbH & Co KG
– Laserliner –
Möhnestraße 149, 59755 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: +49 2932 638-333
laserliner@umarex.de **
8.075.96.03.1 / Rev.0312
Umarex GmbH & Co KG**
Donnerfeld 2
59757 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: -333
www.laserliner.com
Documents / Resources
|
Laserliner RollPilot D12 Electronic Measuring
Wheel
[pdf] Instructions
RollPilot D12, Electronic Measuring Wheel, Measuring Wheel, Electronic Wheel,
RollPilot D12, Wheel
---|---