concept VP 5090 Floor Vacuum Cleaner Instruction Manual

VP 5090

ACKNOWLEDGEMENT

Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place for future reference. Make sure that any persons handling the vacuum cleaner are also familiar with this Operating Manual.

Technical parameters

Voltage| 220–240 V ~ 50/60 Hz
Power input| 1200 W
Noise level| 80 dB

Double or reinforced insulation

IMPORTANT SAFETY PRECAUTIONS

• Do not use this appliance in a way that is different from the instructions in this manual.
• Remove all packaging and marketing materials from the appliance before you use it for the first time.
• Make sure that the connecting voltage corresponds to the values on the appliance type label.
• Do not leave the appliance unattended when turned on or plugged into the electrical socket.
• Disconnect the appliance from the electrical socket when you are not using it.
• Never pull the supply cable when disconnecting the appliance from the electrical socket; pull the plug instead.
• Do not allow children or irresponsible people to handle the appliance. Use the appliance out of the reach of these people.
• Handicapped people, people with impaired faculties or mental capabilities or people unfamiliar with the appliance operation are only allowed to use it when supervised by responsible, knowledgeable people.
• Be especially careful when there are children near the appliance.
• Do not allow the appliance to be used as a toy.
• Do not use the appliance outdoors or on wet surfaces as there is a threat of electric shock in these places.
• Do not use any other accessories except those recommended by the manufacturer.
• Never use the appliance if the supply cable or plug has been damaged; have the defect repaired immediately by an authorized service center.
• Never run over the supply cable with the floor attachment or the appliance itself.
• Provided the rotary brush is used, it may be dangerous to run the appliance over the supply cable.
• Never pull the supply power cord or use it to carry the appliance.
• Keep the appliance away from any sources of heat, such as radiators, ovens, etc. Do not expose the appliance to direct sunlight or moisture.
• Do not touch the appliance with damp or wet hands.
• Do not insert any items into the openings. Do not use the appliance if any of these openings are obstructed.
• Unplugging the appliance from the wall socket, first turn off the main switch, then pull the plug out of the electric voltage socket.
• Take extra care when using the appliance on stairs.
• If the appliance‘s suction inlet becomes obstructed, turn the appliance off and remove any obstructing dirt before turning the appliance on again.
• Hold the supply cable while winding it in order to avoid uncontrolled movement.
• Before fixing any accessories, cleaning, or in the case of a defect turn off the appliance and pull the plug out of the electrical socket.
• Unwind the necessary length of the power supply cord before using the appliance. The ideal length of the power supply cord is marked by a yellow dot on the cord. Do not unwind the power supply cord past the red mark.
• The appliance is intended for household use only (not for commercial use).
• Do not vacuum any burning items such as cigarettes, matches, or hot ash.
• Do not use the appliance in wet rooms; do not vacuum any wet items or liquids, flammable liquids (such as petrol), and do not use the appliance in places where these substances may be present.
• Never vacuum without using the dust collection bag or the appliance‘s filters. Before each using the appliance, make sure the dust collection bag and the appliance‘s filters are properly installed.
• Do not immerse the supply cable, the plug, or the appliance itself into water or any other liquid.
• Check the appliance and the supply cable regularly for any damage. Never turn the appliance on if it is damaged.
• Prior to cleaning and after using the appliance, turn it off, disconnect it from the electric voltage outlet and let it cool.
• Before using the appliance, remove any large or sharp items from the surface you want to vacuum as these items may damage the dust collection bag or the appliance‘s filters.
• Do not use the appliance if the filters are dirty.
• Never repair the appliance by yourself. Instead, contact an authorized service center for repair.
• This appliance may be used by children 8 years of age and older and by persons with physical or mental impairments or by inexperienced persons if they are properly supervised or have been informed about how to use the product in a safe manner and understand the potential dangers. Children must not play with the appliance. This appliance may be cleaned by children 8 years of age and older if they are properly supervised. Keep this appliance and the power cord out of reach of children younger than 8 years of age.

Failure to follow the manufacturer‘s instructions may invalidate the warranty.

PRODUCT DESCRIPTION+

1. Hose holder
2. Telescopic tube
3. Floor attachment
4. Flexible hose
5. Power cord winding button
6. ON/OFF button
7. Container with cyclone unit
8. Carrying handle
9. Air discharge filter

ACCESSORIES
A Slotted nozzle

OPERATING MANUAL

ASSEMBLY OF THE VACUUM CLEANER

NOTE
Before fixing or removing accessories, always pull the plug out of the electrical socket!

1. Connecting the flexible hose to the appliance Insert the flexible hose into the appliance‘s air suction inlet. When the slide throttle is closed, the airflow is stronger. Slide throttle in open position – weaker airflow.
2. Attaching the telescopic tube to the hose adapter Put the telescopic tube on the hose adapter and turn it slightly.
3. Extending the telescopic tube Press the plastic latch and pull the smaller tube outwards.
4. Fixing the floor attachment to the telescopic tube Insert the telescopic tube into the floor attachment and turn it slightly. The flap (Fig. 2) is used for setting the floor attachment to brushing (for
   smooth floors), or to smooth vacuuming (for carpets).

ACCESSORIES
Slot nozzle
The slot nozzle adapter is used for vacuuming places that are difficult to access, such as radiators, slots, corners, pedestals, spaces between upholstery, and others.

USING THE APPLIANCE

NOTE
Before using the appliance, make sure that filters and the dust collection bag are properly positioned and mounted. Unwind the supply cable length you need. The yellow mark on the supply cable indicates the optimum cable length. Do not unwind the supply cable beyond the red mark!

1. Adjust the power controller to the minimum setting.
2. Insert the plug into the main outlet.
3. Press the main switch on the vacuum cleaner.
4. Set the required suction power using the controller.
5. After vacuuming, turn off the product and unplug from the main outlet.
6. To wind the power cord, press the holder in the back position to make it push against the winder button on your other hand to make sure the power cord does not whip around.

CHECKING THE CONTAINER CONTENT LEVEL
If the suction power is lower, or the dust content level indicator is red even though the nozzle is lifted above the floor, empty the container immediately.
NOTE: If the dust level indicator remains red after replacing the container, check for the following:

• some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
• the motor filter is dirty;
• the air outlet filter is dirty.

Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the cause of the problem cannot be identified, hand over the product to the nearest service center. Never use the vacuum cleaner if the bag level indicator is completely red during operation. The motor could be damaged irreparably

MAINTENANCE

As a preventative measure, we recommend emptying the container and cleaning the filters of the vacuum cleaner after each use.

EMPTYING THE CONTAINER

1. Unplug the vacuum cleaner from the mains. Disconnect the hose from the suction inlet.
2. Push the latches, and shift the container upwards (Fig. 3).
3. Press the latch to open the latch and empty the contents of the container (see Fig. 4).
4. Close the container and return it to the vacuum cleaner. Make sure the container is positioned properly.
   You should hear a clicking sound from the handle latches.

REPLACING FILTERS

• The filters should be cleaned or replaced when they are visibly dirty, or if the appliance‘s suction power is reduced. Always check the filters after using the appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly installed filters.
• Before replacing the filters, disconnect the appliance from the electrical socket.
• You can buy suitable types of filters from your dealer, or you can order them from the manufacturer.

CLEANING THE INLET FILTERS

1. Disconnect the flexible hose and remove the container.
2. Open the filter holder of the container (Fig. 5) and remove the foam rubber filter.
3. The foam rubber filter may be cleaned mechanically by shaking them and cleaning with a soft brush. Heavily fouled filters can be washed after this step and cleaned with a  soft brush in lukewarm water. Do not use detergents. It is important to let the wet parts dry thoroughly. Do not use a hair dryer for drying! Wet filters will be damaged if used for vacuuming!
4.  Assemble cleaned or new components and install them in the original location using the reverse procedure.

Note: Wet cleaning can cause more wear and tear on the filter and correspondingly shorter service life. If the vacuum cleaner does not perform with the original suction power, the filters should be replaced with new ones.

CHECKING AND REPLACING THE AIR OUTLET FILTER

1. Open the air outlet grid at the rear section of the vacuum cleaner (see Fig. 6).
2. Remove the filter.
3. The filter can be cleaned by tapping or shaking it. If the filter is extremely dirty, it can be washed in lukewarm water. Let the filter dry completely before using it again.
4. Insert a cleaned or new air outlet filter, and close the air outlet grid.

CLEANING AND MAINTENANCE

The vacuum cleaner and its accessories can be cleaned with a wet cloth.
Do not immerse the power cord, plug, or appliance in water or any other liquid.
Do not use aggressive substances for cleanings, such as solvents or abrasives!

TROUBLESHOOTING

appliance.
The motor has stopped operating.| Improper or insufficient airflow. Motor overheating fuse activated.| Disconnect the cable from the socket. Check and release the air suction
and discharge holes; check the filter’s cleanliness and/or replace the dust bag. Let the vacuum cleaner cool down.
Reduced suction power| Dust bin full or clogged.| Empty and clean the dust bin.
The filters are clogged| Clean or replace the filters.
Clogged nozzle, tube, or hose.| Check and clear the air passage on the suction and discharge sides.
The vacuum cleaner heats up| Slight heating of the vacuum cleaner is normal and cannot be considered a failure.

SERVICE
Any larger maintenance or repairs requiring intervention into the internal parts of the product shall only be performed by an authorized service
ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.

Appliance recycling at the end of its service life:

A symbol on the product or its packaging indicates that this product should not go into household waste. It must be taken to the collection point of an electric and electronic equipment recycling facility. By making sure this product is disposed of properly, you will help prevent the negative effects on the environment and human health that would otherwise result from the inappropriate disposal of this product. You can learn more about recycling this product from your local authorities, a household waste disposal service or in the shop where you bought this product.

This product meets all the basic EU regulation requirements that relate to it.
Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to make these changes.

References

• Concept – chytře vymyšleno pro život
• Domena Concept.pl jest na sprzedaż - SklepDomeny.pl
• Luxury Architecture, Concept Architects, Bratislava
• Concept
• Online software pre autoservis | servis.sk
• Tech.sk | Všetko o informačných technológiáchTech.sk | Magazín o internete a technológiách
• Concept
• Concept – chytře vymyšleno pro život
• Concept innowacje w Twoim życiu!
• www.my-concept.sk | vymyslené pre život
• Verners

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>