audison AFBMW Car Audio Processors Amplifiers Owner’s Manual
- June 9, 2024
- audison
Table of Contents
audison AFBMW Car Audio Processors Amplifiers Owner’s Manual
ACCESSORIES
Packaging contents
AFBMW ReAMP 3
Factory cut-out mounting
AFBMW ReAMP 3
Audison AF bit Amplifier configuration 1: Mid Hi FR/FL + RL/RR + WFL/WFR (Bridged)
SPEAKER OUT CONFIGURATION
1+| Front Mid-Hi Left +| 5+| Front Wf Left +
1-| Front Mid-Hi Left –| 5-| NOT USED
2+| Front Mid-Hi Right +| 6+| NOT USED
2-| Front Mid-Hi Right –| 6-| Front Wf Left –
3+| Rear Left +| 7+| Front Wf Right +
3-| Rear Left –| 7-| NOT USED
4+| Rear Right +| 8+| NOT USED
4-| Rear Right –| 8-| Front Wf Right –
SPEAKER IN COLOR CONNECTOR
WHITE| Front Wf Left
GRAY| Front Wf Right
GREEN| Front Mid-Hi Left
VIOLET| Front Mid-Hi Right
LIGHT BLUE| Rear Left
ORANGE| Rear Right
LIGHT BLUE| Center
YELLOW| NC
AFBMW ReAMP 3
Audison AF bit Amplifier configuration 2: Mid Hi FR/FL + RL/RR + WFL/WFR + Center
SPEAKER OUT CONFIGURATION
1+| Front Mid-Hi Left +| 5+| Front Wf Left +
1-| Front Mid-Hi Left –| 5-| Front Wf Left –
2+| Front Mid-Hi Right +| 6+| Front Wf Right +
2-| Front Mid-Hi Right –| 6-| Front Wf Right –
3+| Rear Left +| 7+| Center +
3-| Rear Left –| 7-| Center –
4+| Rear Right +| 8+| NOT USED
4-| Rear Right –| 8-| NOT USED
SPEAKER IN COLOR CONNECTOR
WHITE| Front Wf Left
GRAY| Front Wf Right
GREEN| Front Mid-Hi Left
VIOLET| Front Mid-Hi Right
LIGHT BLUE| Rear Left
ORANGE| Rear Right
LIGHT BLUE| Center
YELLOW| NC
Technical notes
The AFBMW ReAMP 3 harness interfaces with BMW 676 HiFi systems by using the RAM module (all iDrive 7-equipped vehicles have a RAM module, regardless of audio package). The harness brings the front mid/high, rear mid/high, underseat low-pass and center signals out, and makes those speaker leads available to connect to your amplifier. The outputs of the harness terminate in an input connector for Audison FORZA bit processor, and the speaker leads are terminated with round male connectors. The RAM module must be retained in the vehicle.
BMW RAM in G20 3-Series (left rear corner of trunk)
NOTES :
- Compatibility with RAM module-equipped 676 HiFi audio packages and Audison AF bit amplifier – the use with other products may require modifications and additional connections to the vehicle. – 676 systems use 20 woofers. Do not bridge two channels into a 20 load, since protection shutdown or amplifier damage may result. To use bridged channels, the user needs to replace the OEM 20 woofers with Audison APBMW S8-4 40 woofers. Please, make sure to confirm proper bridge wiring.
- Use the Hi-Level input configuration #11 of the manual (2-way front + rear + center) – this is essential to properly route the input signal to the bit processor section.
- Confirm proper application – APBMW ReAMP 1, APBMW ReAMP 2 and AFBMW ReAMP 3 use identical connectors, but with different pinouts. They are not interchangeable.
- Compatibility with AP F8.9 bit – The AP F IN ADP allows the use of AFBMW ReAMP 3 with the AP F8.9 bit amplifier with full P&P connection.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>