HALBMKIT-ED Command Access Technologies Instructions
- June 3, 2024
- COMMAND ACCESS
Table of Contents
HALBMKIT-ED Command Access Technologies Instructions
INSERT INSTRUCTIONS
FIELD INSTALLABLE HAGER 4500, PDQ 6200 & LAWRENCE RIM 8000 SERIES EXIT DEVICE
KIT INCLUDES
- 1- LBM Bracket
- 1- LBM Color code sticker
- 1- 40226 Phillips Pan Head w/ LW 6-32 x 1/2”
- 1- Cable Tie
- 1- Sticky Pad
- 1- 60754 Cap
TOOLS REQUIRED
Cordless Drill or Phillips Screwdriver
SPECIFICATIONS
- Single Pole – Double Throw (SPDT)
- Rating: .5A @24VAC
- Configuration: Green/Black – Common (C)
- Blue/Black – Normally Open (NO)
- Gray/Black – Normally Closed (NC)
INSTALLATION INSTRUCTIONS
- REMOVE THE HEAD COVER & (2) SCREWS SECURING HOUSING TO PUSH PAD
- SLIDE THE HOUSING OFF & PUSH LBM BRACKET INTO EXSITING HOLES ON THE EXIT DEVICE
- RUN THE LBM WIRES DOWN THE PUSH PAD TO THE BACK OF THE DEVICE & SLIDE HOUSING BACK ON KEEPING WIRES IN THE LOWER CHANNEL.
- REMOVE LBM BRACKET & RE-INSTALL (2) SCREWS TO SECURE HOUSING TO PUSH PAD.
- SLIDE ARM OF THE LBM BRACKET INTO THE OPENING AT THE BOTTOM OF THE EXIT DEVICE HEAD
- PUSH THE TWO TABS ON THE LBM BRAKET INTO THE EXISTING HOLES IN THE EXIT DEVICE HEAD
- CONFIRM SWITCH ARM IS UNDERNEATH RIM LATCH PIN. INSTALL (1) 40266 SCREW INTO TOP HOLE ON LBM BRACKET TO SECURE BRACKET TO EXIT DEVICE HEAD.
- INSTALL (1) 60754 CAP ON TO LATCHBOLT ROLL PIN.
- PULL WIRE SLACK AND ADD CABLE TIE & STICKY PAD FOR A STRAIN RELIEF. ADD LBM COLOR CODE STICKER
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>