COMMAND ACCESS TECHNOLOGIES V23 Von Duprin 230L Series Exit Tirm Satin Instruction Manual

June 3, 2024
COMMAND ACCESS TECHNOLOGIES

COMMAND ACCESS TECHNOLOGIES V23 Von Duprin 230L Series Exit Tirm Satin Instruction Manual

Von Duprin Electric Exit Trim modified by Command Access Technologies

The door must be machined with a 3/8” wire raceway, Exit Trim & prepped for a energy transfer hinge. Make sure the pocket is free of debris.

![. Make sure

the pocket is free of debris.](https://manuals.plus/wp- content/uploads/2022/12/Screenshot_1-482.jpg)

Run the wires from the ETH hinge through the 3/8” raceway starting at the ETH hinge & exiting into the pocket

Instraction

: Screw the ETH hinge to the door. At this time DO NOT connect the hinge wires on the jamb side to the wires coming from the power supply.

Connect the wires exiting the pocket to the Bridge Rectifier (included)

Connect the wires exiting the pocke

Connect the Bridge Rectifier to the plug exiting the Electric Exit Trim

Connect the Bridge Rectifier

Carefully slip the connected Electric Exit Trim into the pocket paying close attention not to pinch any wires.

Mount the Electric Exit Trim per manufacturer’s instructions.

Connect the wires from the power supply at the ETH hinge on the jamb side. Connect the hinge to the jamb.

LEGEND OF TERMS

EU: (Fail Secure) When power is applied, the outside trim will unlock. When power is removed, the outside trim is locked.
EL: (Fail Safe) When power is applied, the outside trim will lock. When power is removed, the outside trim is unlocked.
REE: (Request to Enter Switch) Monitors the outside handle.

LEGEND OF TERMS

ELECTRICAL SPECIFICATIONS

SOLENOIDS

VOLTS
24
VAC/DC
12VAC/D C

CURRENT
150mA
250mA

COIL RESISTANCE

159 Ohms +/- 10%
49 Ohms +/- 10%

SWITCHES: .5A 24VAC/DC

REE:
Green – Common (C)
Blue – Normally Open (NO)
Gray – Normally Closed (NC)

Template for Von Duprin 230L Series Exit Trims

Template for Von Duprin 230L Series Exit Trims

Handing for Von Duprin 230L Series Exit Trims

  • To Change the handing, removing the retaining ring
    To Change the handing,

  • Use a screwdriver to push ip the slider leg to remove any load from the lever and remove lever cam

  • Remove the shear pin
    Remove the shear pin

  • Rotate the lever to the desired position. Re-install shear pin
    Re-install shear pin

  • Re-install lever cam with the correct letter visiable. R=RHR & L=LHR

  • Re-install the retaining ring
    R=RHR & L=LHR

support

Phone: 888-622-2377
www.CommandAccess.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals