PNi K80 Power Supply Control User Manual
- June 3, 2024
- PNI
Table of Contents
PNi K80 Power Supply Control
MAIN FEATURES
- Small size
- Reliability
- Electrical overload protection
- Input overvoltage protection
- External energized pulse type control 6 – 32V (<1 second) on Control + / Control-
- Compatible with recessed/applied Fail Safe and Fail Secure electromagnetic closures
- Compatible with built-in / applied Fail Safe and Fail Secure mechanical locks
- Timed output
TECHNICAL SPECIFICATIONS
- Input voltage: 110 – 260 V a.c.
- Input frequency: 50 – 60 Hz
- Output voltage: 12 V c.c.
- Output current: 3A
- Output stability: 0.5%
- Full load hold time: 20ms
- Operating themperature: -26°C ~ +80°C
- Output delay: 0-15 sec
- Size: 105 x 91 x 34 mm
- Weight: 320g
WIRING DIAGRAM
Warning: Please set the power source with 0 sec delay for retention of electromagnetic locks, to avoid damaging them. For nonretention electromagnetic locks set the delay time according to their specifications, to avoid damaging them.
WARNING
- We recommend that the installation and connection to be done by qualified personnel who can correctly understand all the specific technical terms, schemes and technical verification procedures.
- For locks and electromagnetic locks with retention, the power source will be set with a delay of 0 seconds, to prevent their burning.
- For locks and electromagnetic locks without restraint, the timing will be set according to the specifications of the lock, to prevent it from burning.
- The NO (Normal Open) energized output control is designed to operate the Fail Safe electromagnetic locks.
- The NC (Normal Close) is designed to operate the Fail Safe electromagnetic locks.
- Thepower source can also receive the opening command on the Control + and Control – connectors with an energized pulse type command with a voltage between 6-32V DC (<1 second, respecting the polarity).
- Carefully consult the technical documentation of the electromagnetic locks before connecting them to the power source, in order to avoid incorrect connection and irreparable damage to the equipment.
EU Simplified Declaration of Conformity
SC ONLINESHOP SRL declares that PNI K80 power source with timing complies with
the Directive EMC 2014/30/EU. The full text of the EU declaration of
conformity is available at the following Internet address:
https://www.mypni.eu/products/928/download/certifications
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>