RETRO FIGHTERS Brawler 64 Wireless Gamepad Instruction Manual
- June 8, 2024
- RETRO FIGHTERS
Table of Contents
RETRO FIGHTERS Brawler 64 Wireless Gamepad
- D-Pad
- Analog Stick
- LED Indicator
- Z Button (Right)
- Pairing Button (Back)
- Home Button
- Screen Shot (Top L)
- Swapping Button (Top R)
- CDown
- CU
- Button
- Button (Start)
- LShoulder Button
- R Shoulder Button
- Z Button (Left)
- B Button
- AButton
- CLeft
- Right
how to pair
- Make sure that “Pro Wired Communication” is turned “OFF” in system settings.
- Press the back pairing button for at least 3 seconds until LEDs flash quickly.
- Switch will connect to the gamepad automatically.
Powering off
- Press back button to turn off your gamepad.
Xinput to Dinput mode
- Gamepad defaults to Xinput mode, to switch between modes press “-” and “START” for 3 seconds
gamepad reset
- Press and hold the “HOME” button lasting at least 10 seconds to reset the gamepad.
LED indicators
FAUS
How dol charge?
- Use the provided USB-C cable with a USB compatible charging block (not included). Once charging the LED light on the controller will continuously blink indicating it is currently charging. Once the controller is fully charged it will stop blinking. This process takes approximately 2.5 hours on low/ empty battery.
How long is the battery life?
- Approximately 10 hours before you need to recharge.
What systems are compatible?
- The gamepad is compatible with Switch and PC.
What is the default button layout?
- The default button layout is the button layout for NSO. To switch to “Pro Controller” layout simply press the Swap button.
How do I make it work on PC?
- Connect your USB-C cable directly to your PC, it connects via wired connection.
How do I awaken my Switch system?
- Simply press the Home button to awaken your Switch system and reconnect.
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two
conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment The devices has been evaluated to meet general RF exposure requirement， the device can be used in portable exposure condition without estriction
CUstomer seruice
We strive to make our fellow gamers happy. If you experience any issues with
this product please contact us directly. We are here to help and we will make
it right! You can send us an email at:
support@retrofighters.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>