fisher-price HGM26 Baby and Toddler Toy 2 Sided Steady Speed Panda Walker User Manual
- June 13, 2024
- fisher-price
Table of Contents
HGM26
2-Sided Steady Speed™ Panda Walker
ASSEMBLY GUIDE
Before You Begin
| Keep these instructions for future reference as they contain important
information.
---|---
| Three AA batteries are required (not included).
Alkaline batteries make this toy work longer before you need to change them.
| Clean with a damp cloth. Do not immerse.
| Adult assembly is required (because we needed to fit this toy in the box).
| Plan on about 10 minutes for assembly.
| You’ll need a Phillips screwdriver (not included) for assembly and battery
installation. Do not over-tighten assembled screws or the screw in the
battery door.
Assembled Parts
CAUTION
This package contains small parts.
For adult assembly only.
Assembly
Pull up on the handle to be sure it’s secure.
Install Batteries
Loosen the screw in the battery door and remove the door.
Insert three, new AA (LR6) alkaline batteries. Make sure you insert the
batteries correctly!
Replace the battery door and tighten the screw.
You may need to reset the electronics if this toy begins to operate
erratically. Slide the power-mode switch off and back on.
When sound or lights become faint or stop, it’s time for an adult to change
the batteries.
Power & Modes
- Explore – Enjoy fun sounds, music, first words and phrases that introduce opposite and colors!
- Encourage – Along with sounds, phrases and songs about the alphabet and counting, listen for a fun prompt followed by a reward!
- Pretend – Listen to engaging music and phrases that inspire imaginative play!
Off
Walk along for more music, phrases and sound effects.
If motion doesn’t activate the toy, be sure to press any button or toggle the
shifter to wake the toy up.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
- Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable.
- Insert batteries as indicated inside the battery compartment (+ and -).
- Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak.
- Never short-circuit the battery terminals.
- Use only batteries of the same or equivalent type, as recommended.
- Do not charge non-rechargeable batteries.
- Remove rechargeable batteries from the product before charging.
- If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
**** Protect the environment by not disposing of this product or any batteries with household waste. This symbol indicates that this product shall not be treated as household waste. Check your local authority for recycling advice and facilities.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
UNITED STATES
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Consumer Services: 1-800-432-5437.
CANADA
Mattel Canada Inc., 6155 Freemont Blvd., Mississauga,
Ontario L5R 3W2 Consumer Services/Service à la clientèle :
1-800-432-5437.
www.service.mattel.com.
GREAT BRITAIN
Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK.
www.service.mattel.com/uk.
NEDERLAND
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
SOUTH AFRICA
Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard,
Johannesburg 2196.
HGM26-0970-G1
1102758735-DOM
©2022 Matt el.
PRINTED IN CHINA
Documents / Resources
|
fisher-price HGM26 Baby and Toddler Toy 2 Sided Steady Speed Panda
Walker
[pdf] User Manual
HGM26 Baby and Toddler Toy 2 Sided Steady Speed Panda Walker, HGM26, Baby and
Toddler Toy 2 Sided Steady Speed Panda Walker, Sided Steady Speed Panda
Walker, Speed Panda Walker
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>