AUDIBAX Kansas Amplificador User Manual

June 3, 2024
AUDIBAX

Kansas Amplificador
User Manual

Please read the manual before using the product

Remote control function

1. Mode 7. Play next key
2. Power 8. Volume reduce key
3. Pause 9. Volume add key
4. EQ 10. Repeat
5. Ventil 11. SD/USB converter
6. Play precede key

SAFETY MEASURE

  1. The unit should be connected to a power supply of 220V± 10% 50Hz, If the power supply that you used isn’t correct, the unit will be damaged.
  2. The unit must be used after being connected to the effective ground wire and cannot be operated by the people or the children who do not know about electrical  appliances.
  3. Keep the unit away from any water source heat source (e.g. Fire or electric shock) to avoid leakage of electricity.
  4. Do not remove the enclosure and touch the internal parts at will to avoid electric shock.
  5. Please shut off the power if the unit isn’t used for a long time.
  6. Be more careful when using the unit in a bad weather, lt’s better not to use it and pull out the plug.
  7. When pulling the plug out of the socket, please hold the plastic part of the plug.
  8. Do not turn on the power switch until you connect the system and be sure it is correct.

Function manual of front panel

AUDIBAX Kansas Amplificador - Figure 2

  1. The power button.
  2. Bass adjusting control.
  3. Treble adjusting control.
  4. The volume control.
  5. Upward play button key.
  6. Pause/play key.
  7. Down the play button key.
  8. MP3 DVD Bluetooth Signal conversion key display.
  9. LED display.
  10. USB disk interface.
  11. TF card interface.

Function manual of rear panel

AUDIBAX Kansas Amplificador - Figure 3

  1. DVD Audio signal input.
  2. R right channel speaker output.
  3. L left channel speaker output.
  4. The DC12V supply input.
  5. The AC220V supply input.
  6. FM. antenna.

SPECIFICATIONS

  • SPECIFICATIONS
  • Speaker impedance 8 to 16 ohm
  • SNR(signal Noise Ratio)-100dbn
  • Input power=12Volts DC5AMPS~AC220V
  • Input impedance=47K
  • Output power R.M.S 10W
  • Speaker impedance 8 to 16 ohm
  • SNR(signal Noise Ratio)-100dbn
  • Input power=12Volts DC5AMPS~AC220V
  • Input impedance=47K
  • Output power R.M.S 10W

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals