AUDIBAX Arkansas 10 Inch Professional Bluetooth Speaker User Manual

AUDIBAX Arkansas 10 Inch Professional Bluetooth Speaker

Please read the manual before using the product

IMPORTANT SAFETY SYMBOLS

Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

Intended  to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product

CAUTION : Risk of electrical shock – DO NOT OPEN!
CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside. Refer servicing to qualified service personnel.
WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases,should not be placed on this apparatus. Befare using this apparatus, read the operating guide for further warnings.

Protective earthing terminal. The apparatus should be connected to a mains socket outlet with a protective earthing connection.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any of the ventilation openings. lnstall in accordance with manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. lf the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11. Only use attachments/ accessories provided by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15. 15. Never break off the ground pin. Write for our free booklet “Shock Hazard and Grounding.”
    Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

16. lf this product is to be mounted in an equipment rack; rear support should be provided.

17. This electrical apparatus should not be exposed to dripping or splashing and care should be taken not to place objects containing liquids, such as vases, upon the apparatus.

18. The on/off switch in this unit does not break both sides of the primary mains. Hazardous energy can be present inside the chassis when the on/off switch is in the off position. The mains plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.

Panel control instruction

1. Level
   This knob is used to adjust the output of Mic in

2. Level
   This knob is used to adjust the output of the line in

3. Volume
   This knob is used to adjust the total output of the complete product

4. 2-Band EQ
   Treble: This knob is used to adjust the high frequency Bass: This knob is used to adjust the low frequency

5. Line in (XLR & RCA)
   This input is used to plug in audio cable to get signal from CD player or other devices

6. Mic in (XLR&1/4″ jack)
   This input is used to plug in microphone cable to get signal from dynamic microphone

7. Line out (XLR & 1/4″ jack)
   This input is used to output signal to another active speaker box or amplifier

8. Power switch
   Turn on / off the power supply to the product

9. AC Power Socket
   It is used to connect the power supply to the unit via enclosed power cord

10. Fuse Holder
    The fuse holder is for containing the fuse, which is a safety device that protects the AC supplies circuit of the unit

11. MP3 Player instruction

12. Mode
    Press Mode button to choose the work modes in the mp3 player like USB/SD/FM/Bluetooth, if
    press mode button for a few seconds, it will enter folder track mode.

13. Play /Pause
    Press this button to play the mp3 player or pause the mp3 player, when the mp3 player work
    at FM mode, press this button to seam the stations automatically

14. Stop
    Press this button to stop the mp3 player

15. Recycle
    Press this button to play music recycle

16. Backward
    Press this button to play last song or look for last FM station

17. Forward
    Press this button to play next song or look for next FM station

Caution: if the fuse blew out, it should be replaced with the same type and specification . if the fuse continues to blow out, please stop using and refer servicing to qualified personnel

Specification Chart

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>