AUDIBAX Dayton 400 BT Portable Speaker User Manual
- October 28, 2023
- AUDIBAX
Table of Contents
USER´S MANUAL
Please read the manual before using the product
OPERATION
Functions
-
[BT] Bluetooth® connection button
-
[TWS] TWS connection button
-
[DSP PRESETS] Push button switch for presets DSP. Use the button to switch between MAIN, HIFI, MONITOR, DJ, SPEECH.
-
[MASTER] Rotary control to adjust the overall volume
-
[TREBLE] Rotary control for adjusting the treble effect of the input signal at the line input of channel 1, 2 or 3.
-
[BASS] Rotary control for adjusting the bass effect of the input signal at the line input of channel 1, 2 or 3.
-
[VOLUME] Rotary control for adjusting the volume of the input signal at the line input of channel 1, 2 or 3/4.
-
[MIC] / [GUITAR] / [LINE] for channel 1 and 2 Toggle switch for the input signal of the respective channel. Use these buttons to switch between mic, guitar and line input.
-
[CH1] & [CH2] Mic / guitar / line inputs, designed as XLR input socket, 3-pin.
-
[LINE] / [BT] Toggle switch for the input signal of the respective channel. Use these buttons to switch between line and BT input.
When pressed, [BT] the bluetooth signal is played. When not pressed, [LINE] the line signal is played. . -
[CH3/4] Line input, designed as RCA input socket.
-
[LINE OUT] Line output, designed as XLR output socket, 3-pin.
-
[AUX] 3.5 mm mini jack socket to connect an external audio device (CD or MP3 player).
-
Main supply inlet: Connect an IEC main power cable to supply the unit.
-
Power switch: It allows to switch on / off the unit.
Safety Precautions
Do not clean the plastic enclosure with solvents or other chemical based
cleaning products.
Do not place heat such as lighting equipment and smoke machines on the speaker
cabinet.
Keep the device away from rain and moisture!
Always place the device in a secure manner to prevent the device from causing
injury.
Damages caused by the disregard of this user manual are not subject to
warranty. The dealer will not accept liability for any resulting defects or
problems.
Additional precautions
The device is designed use in dry conditions only.
Handle the power cord and all connections to the main power with particular
caution!
The device should only be connected to 230V AC,50 Hz.
Never handle the power cord or the device when wet, as this could lead to
electronic shock.
Make sure the power-cord is in perfect condition before connecting.
Only handle the power-cord by the plug.
Always insert the power plug last. The power plug must always be interested
without force.
Make sure that the power plug is tightly connected with the outlet.
Never let the power cord come into contact with other cables.
Only replace the fuse when the device is disconnected from the main power.
Only use fuses of the same rating and power. The correct fuse value is
specified on the rear panel.