EKO EK9260 Mirage X Sensor Bin Instructions

EKO EK9260 Mirage X Sensor Bin

Thank you for choosing the MIRAGE X SENSOR BIN Please read these instructions before using the product. Graphics are for illustrative purposes only.

Product Introduction

Back of lid (EK9260R)

Back of lid (EK9260)

Power Supply

6 AA alkaline batteries and outlet/adaptor not included

1. EK9260
   Turn to the bottom of the lid, press down and slide open the battery box cover. Insert 6 AA alkaline batteries according to directions in the battery box.

2. Insert 6 AA alkaline batteries according to directions in the battery box.

3. Do not use rechargeable batteries.

4. EK9260R

5. Connect to power cord
   Plug the power cord into the micro USB port(Micro-USB B) in the back, connect the other end to a power adaptor and outlet for direct power supply. Adaptor is not included.

6. Recharge the bin
   To charge the bin, connect the micro USB side of the cable to the micro USB port on the side of the sensor lid, then connect the other side of the cable to any power supply outlet/adaptor with a USB plug.

Power ON/OFF

1. Turn the power switch on. Make sure sensor switch is also in the ON position.
2. Sensor panel lights up to signal power on. LED light flashes every 6 seconds when bin is in standby mode.

Standby mode with sensor
Light on the left flashes indicating sensor function is activated.

Standby mode with touch
Light on the right flashes indicating touch buttons function only, no sensor function.

Operating Instructions

Sensor Mode

Sensor Open/Close Place hand or object 20cm (±5cm) directly above the sensor panel to open the bin. All LED signal lights will turn on.

5 seconds automatic countdown close: LED signal lights count down 5 seconds before the bin automatically closes.

Stay Open
Keep hand or object within the sensor range to keep bin open, or use touch buttons to operate the bin.

Manual mode
When lid has been opened using the touch button, the lid must be closed by lightly pressing the button.

Sensor OFF
If sensor switch is turned to off, the bin can only be operated by touch buttons(manual mode).

Change Bin Bag

Depending on waste sorting and recycling needs, use with or without bin bags.

1. Pull out and tighten the drawstrings, then remove the bin bag.
2. Replace the bin bag and insert excess bin bag into the bag stabilizer on the inner bucket. Or take out the liner ring, fold the edge of the bin bag over the liner ring, place back into the bin. Place the lid back on top of the bin.
3. Deodorizer compartment is located at the front inner side of the lid. Open the cover of deodorizer compartment. Insert deodorizer into the compartment, then close the cover. *Deodorizer not included

EKO Accessories Guide

Custom fit like a match made in heaven. Maximize the functionality of our products by pairing them with custom fit liners, batteries, and odour filters.

EKO BIN LINERS
Integrated drawstring handles so they are easy to lift, tie, and carry.

Bin Liners Size Guide

Built in deodorizer compartment can be used with EKO odour filter or EKO perfume capsules.

EKO Charcoal Odour Filter EKO Grancy Perfume Capsules

Product Packing List

• 1 Lid 1 Body
• 1 Inner bucket (Single inner bucket only)
• 2 Inner buckets (Double inner buckets only)
• 1 Liner ring (Without inner bucket only)
• 1 Instructions manual
• 1 Micro-USB B cord (EK9260R only)

Attention

1. When installing batteries, please mind the battery polarity.
2. Avoid use under long exposure to direct sunlight and humidity.
3. Avoid manual force on the bin’s lid during operation.
4. Wipe lid with clean dry cloth and do not clean with running water.
5. If lid contacts water, remove the battery compartment cover and air dry the lid before use.
6. Avoid pressure on the lid and repeated flipping of the lid.
7. Replace batteries timely when low power signal is on.
8. Keep sensor panel clean for optimal use.
9. Keep away from heat, wind sources and high traffic areas.
10. Do not mix old and new alkaline batteries and do not use rechargeable or acid-based batteries.
11. Please do not disassemble or attempt repair of the product on your own

Troubleshooting

1. No lights on – Please make sure the batteries are installed correctly or try new batteries.
2. No response from sensor – The lid may have been closed by hand in manual mode. Pressing “ ” will reset the modes.
3. Sensor lid does not open fully – Indicates low power, please replace batteries with 6 new AA alkaline batteries.
4. Adaptor
   Adaptor not included. Please use adaptors that comply with regulations. Recommended adaptor with input voltage DC 5V, input current 1A.

Battery and Safety Instructions

1. Only adults should handle batteries.
2. Always use the correct type of batteries (AA alkaline batteries).
3. Always use all new batteries.
4. Do not use rechargeable batteries.
5. Do not mix old and new batteries, or batteries of different types.
6. Remove batteries from equipment which is not to be used for an extended period of time.
7. For recycling and disposal of batteries, please check and comply with your local regulations

Product Warranty

Not covered by warranty

1. Damages due to user mishandling or other than its intended use in a typical household activity .
2. Damages due to natural disasters such as fire, earthquake, flood and other Force Majeur events.
3. Damages including dents, scratches, and water damage due to transport handled by the user.
4. Any modification to the product, including disassembly or attempts to repair by the user.
5. Intentional damage to the product.

To request after-sales service, please provide proof of purchase from EKO authorized retail channels.

All copyrights belong to EKO.

We apologize for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>