amazon LED Value UFO Highbay User Guide
- June 7, 2024
- Amazon
Table of Contents
Amazon LED Value UFO
Highbay
IMPORTANT SAFEGUARDS
Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:
Cautions: Risk of electric shock! To prevent risk of electric
shock, turn off the power at the main circuit breaker box before installation.
Warning: Risk of fire! Most dwellings built before 1985 have supply
wiring rated up to 140 °F (60 ºC). Consult a qualified electrician before
installation
Cautions: Risk of fire! Do not install the product on a radiant heating ceiling.
Cautions: Risk of electric shock! This product must be installed in accordance with the applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved. Consult a qualified electrician to ensure correct branch circuit conductor
Cautions: Risk of eye damage! LEDs emit bright light. Avoid looking directly into the light source for prolonged periods.
- This product is rated 120-277 VAC and must be connected to a suitable power source.
- This product is not intended for recessed installation in ceilings, or soffits.
- Do not install any lighting assembly closer than 6″ (15 cm) from any curtain or similar combustible material.
- The product employs non-replaceable LED light sources.
- Contact the municipal building department to learn about applicable local codes, permits and/or inspections.
- This product is intended for use in accordance with the National Electrical Code, ANSI/NFPA 70, and the Canadian Electrical Code, Part I, in non-hazardous locations, and the Mexican Electrical Code [Instalaciones Eléctricas (utilización), NOM-001-SEDE].
- Use this product only with the provided hook. Replacement hook should be able to withstand 5 times the weight of the product. SAVE THESE INSTRUCTIONS
Intended Use
- This product is intended for commercial and residential use.
- This product is rated IP65 and it is suitable for indoor and outdoor use.
- This product is not intended for use with emergency exits.
- This product can be used with 0 – 10 V dimmer (sold separately).
- No liability will be accepted for damages resulting from improper use or non-compliance with these instructions
Before First Use
- Check the product for transport damages.
- Remove all the packing materials
Danger: Risk of suffocation! Keep any packaging materials away from children – these materials are a potential source of danger, e.g. suffocation.
Installation Instructions
Danger: Risk of falling object! The mounting surface should be able to
withstand 5 times the weight of the product.
Risk of electric shock! Disconnect power beforeinstallation.
Warning: Take special precautions when working on heights, for example, while using a ladder. Use the right type of ladder and ensure it is structurally sound. Use the ladder in accordance with the manufacturer’s instructions
NOTICE: This product should be mounted in a horizontal position only with
the light source pointing down.
- Screw the hook (B) and the nut (C) tightly.
- Fix the product onto a heavy-duty anchor hook or other suitable fixing point.
- As added protection, secure the product to an additional mounting point using a safety line (not provided). The safety line should be able to withstand 5 times the weight of the product.
Wiring
WARNING: Risk of electric shock! To prevent risk of electric shock, turn
off the power at the main circuit breaker box before installation.
WARNING: Risk of electric shock! This product must be connected to a
properly grounded electrical system. Never wire the product to a two-wire
system that is not grounded. Contact a qualified electrician for information
with regards to proper grounding methods as required by the local electrical
code in your area.
NOTICE : There is an optional 0 – 10 V dimming circuit/dimmer forthis
product (sold separately.
- Use twist-on wire connectors to join the wires.
Cleaning
WARNING: Risk of electric shock! To prevent electric shock, turn off the power at the main circuit breaker box before cleaning.
- To clean the product, wipe with a soft, slightly moist cloth.
- Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.
FCC – Supplier’s Declaration of Conformity
Unique Identifier: B081415T9W – LED Value UFO Highbay, 50 Watt, 25000
Hours, Dimmable 0-10V, 6500 Lumens, ETL and DLC Certified, Daylight, 1-Pack
B0813ZSVKJ – LED Value UFO Highbay, 130 Watt, 25000 Hours, Dimmable 0-10V,
18000 Lumens, ETL and DLC Certified, Daylight, 1-Pack B0813ZFSYQ – LED Value
UFO Highbay, 175 Watt, 25000 Hours, Dimmable 0-10V, 24000 Lumens, ETL and DLC
Certified, Daylight, 1-Pack B0813ZHRM2 – LED Value UFO Highbay,
220 Watt, 25000 Hours, Dimmable 0-10V, 30000 Lumens, ETL and DLC Certified,
Daylight, 1-Pack
Responsible Party: Amazon.com Services, Inc
U.S. Contact Information: 410 Terry Ave N. Seattle, WA98109, United
States
Telephone Number: 206-266-1000
FCC Compliance Statement
- This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Canada IC Notice
This Class B digital apparatus complies with Canadian CAN ICES-005(B) / NMB-005(B) standard.
Specifications
Feedback and Help
Love it? Hate it? Let us know with a customer review. Amazon Commercial is committed to delivering customer-driven products that live up to your high standards. We encourage you to write a review sharing your experiences with the product.
amazon.com/review/review-your-purchases#
amazon.com/gp/help/customer/contact-us
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>