delta UH4000 Ball Storage Garage Organizer Instruction Manual
- May 15, 2024
- Delta
Table of Contents
delta UH4000 Ball Storage Garage Organizer
Assembly instructions
- Assemble unit by inserting pressed wire ends into slots on plastic base and snap in back plate.
- Identify where wooden stud lies within wall, drill pilot holes for wood screws.
- Secure to wall by tightening both screws.
WARNING : Do not exceed maximum total weight limit of 4.5kg/10lbs. To avoid injury, Do not overload.
Parts
- A : x1 — Back Plate
- B : x2 — Wire Ends
- C : x1 — Front Plate
- D : x2 — Screws
- E : x1 — Net
Tools Required
Hand Drill 1/8″ (3mm)
Way of locating studs within the wall (see hardware store for advice)
Multi Ball Holder Storage Net
-
Identify where wooden stud lies within wall, drill pilot holes for wood screws.
Place front plate on the corner of a table/FLat surface. Position wire ends face down into slots of front plate Slide under small center plate. (FIGURE 1).
NOTE : Be sure front of wire ends are facing down. Insert back plate on top. Be sure wire ends are covered and fit securely between back and front plates. (FIGURE 2) -
Once assembled, transport to pre-drilled wall location. Secure to wall with both screws
-
After wall installation, s 3 lide net onto each arm.
WARNING : Do not exceed maximum total weight limit of 4.5kg/10lbs. To
avoid injury, Do not overload.
Service : Please do not return to store; for immediate response email
service@designbydelta.com
Documents / Resources
|
delta UH4000 Ball Storage Garage
Organizer
[pdf] Instruction Manual
UH4000 Ball Storage Garage Organizer, UH4000, Ball Storage Garage Organizer,
Storage Garage Organizer, Garage Organizer, Organizer
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>