CYC MOTOR DS103 Display Cycmotor User Guide
- June 1, 2024
- CYC Motor
Table of Contents
- Required Tools and Software
- Getting Started – Download TPSERVICE
- Step 1: Connect the programming cable
- Step 2: Select the correct COM port
- Step 3: Choose the update firmware
- Step 4: Plug in the display
- Step 5: Disconnect the display
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
DS103 DISPLAY
Firmware Update Guide
Required Tools and Software
| Programming cable
---|---
| Wiring harness with display connector
| DS103 display
| Battery
|
TPSERVICE (software)
*Please note that the above images are for reference only.
Getting Started – Download TPSERVICE
Click the link below and press the “Download” button:
https://www.dropbox.com/scl/fi/6npjj91n5rlayllaqd3vx/TPSERVICE-with-
SW102-DS103-Firmware.zip?rlkey=ccda8bv9xxpph7uhipgs1n9ky&dl=0.
Extract the downloaded zip file, TPSERVICE with SW102&DS103 Firmware.zip. Then extract the zip file TPSERVICE.zip, inside the folder TPSERVICE with SW102&DS103 Firmware.
Launch the TPSERVICE.exe file and follow the setup instructions.
After installing the software successfully, TPSERVICE is downloaded to your computer and can now be able to run.
Step 1: Connect the programming cable
Ensure that you have the TPSERVICE software installed, Double click the icon of TPSERVICE
Check the UART drop-down, remember the COM port you have at beginning. For example, the image below has COM4 & COM5.
Connect the programming cable to the battery.
Plug the USB to the PC’s USB port. The opposite end of the programming cable is connected to the main connector of the wiring harness. Afterwards, connect the DS103 display to the display connector of the wiring harness.
Step 2: Select the correct COM port
Press the UART drop-down menu and select the appropriate COM port as each programming cable may use a different COM port. For example, COM3 is the port for this programming cable.
Select “DS103” under “Product:” and select “COM” port of your programming cable under the drop-down menu. In this example, we’ve selected COM3 for this programming cable.
Step 3: Choose the update firmware
Press the “Update File:” button and select the respective file based on the
battery voltage of your display from the folder.
For the DS103 52V Display, please select the
“DS103A_Cyc_KM5S_V2.1.16.2@20221209(2).zip.
For the DS103 72V Display, please select the
“72V_DS103A_Cyc_KM5S_V2.1.16.9_20230817.zip
WARNING: Uploading the wrong firmware file to your display will cause irreversible damage which will not be warrantied. Ensure that you upload the firmware version that matches your display version by following the provided guidelines carefully.
Step 4: Plug in the display
Click the “Connect” button on the dashboard.
Click on the “Update” button to install the selected display firmware version.
Right after, quickly press and hold the orange power button of the DS103 display for 1 second. It will prompt that the display is now connected.
Then wait for 5 seconds, the firmware update procedure will start automatically.
Step 5: Disconnect the display
After the update has been 100% installed, click the “Disconnect” button and unplug the DS103 display.
For technical assistance, kindly reach out to us at technical_support@cycmotor.com. Thanks!
© 2023 CYC MOTOR LTD
CYC MOTOR LTD
support@cycmotor.com
+852 3690 8938
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>