GIANNI RTS Series Wave Sense Infrared Exit Devices Instruction Manual
- June 3, 2024
- GIANNI
Table of Contents
GIANNI RTS Series Wave Sense Infrared Exit Devices
Specifications
- Operating Voltage: 12~24VDC
- Current Draw: Pull in 20mA/12VDC; Holding 30mA/12VDC Pull in 30mA/24VDC; Holding 40mA/24VDC
- Relay Rating: 1A/125VAC, 2A/30VDC
- Operating Temperature: -10~+70ºC
- Ambient Humidity: 5~95%
- Dual LED Status Indicator: Standby (Red), Active (Green)
- IR Sense Technology: Active with wave of the hand
- Sensor Range: 3~15 cm
- Adjustable Output Time: 1~60 seconds
- Faceplate Finish:
- RTS-850/860: Plastic ABS
- RTS-870/880: Stainless Steel
Adjusting Sensor Range & Trigger Time
Dimensions
Wiring Diagrams
The RTS series wave sense infrared exit device includes one set of output contacts NC/NO/COM. It can be connected to an access control device (e.g. keypads or proximity readers) as shown in Figure A or can directly control electric locks (e.g. maglocks or electric strikes) as shown in Figure B. In Figure A, the RTS series connects to the Request-to-Exit input terminal of the access control system. Relay output time can be reduced to a minimum of 0.5 seconds. In Figure B, the RTS series controls a fail-safe locking device. When connecting with a fail-secure lock, wire to the NO contact. Relay output time is door opening time.
Caution:
To avoid wire burning, do not exceed the maximum relay rating: 1A/30VDC.
Copyright © All Rights Reserved. P-MU-RTS850N1 Published: 2022.05.25