GIANNI GS250 Series Mini Shear Lock Instruction Manual

June 3, 2024
GIANNI

GIANNI GS250 Series Mini Shear Lock

Technical Specification

Operating Voltage 12/24VDC
Current Draw 500mA/12VDC ; 250mA/24VDC
Operating Temperature 32° to +120.2°F ( 0° to +49°C )
Holding Force 1200 lbs
Surface Temperature ≤ Current temperature +20 °C
Door Gap 2mm
Humidity 0 to 85% Non condensing
Finish Magnet and Armature: Zinc plated

GIANNI GS250 Series Mini Shear Lock 1

Dimension & Accessories

GIANNI GS250 Series Mini Shear Lock 2

Wiring Diagram – Sample wiring and applications

GIANNI GS250 Series Mini Shear Lock 3

Important Notes

  • Make sure that the door and frame is wide and deep enough to install the shear lock. Make sure the central lines on the door frame and door leaf align. Install the magnet into the door frame before installing the armature assembly into the door leaf.
  • Before installation, make sure the door always returns to the dead center after it is opened, especially with double-action doors. Use door hinges if necessary.

Armature Plate Set Screws

Tighten the set screws with the Allen wrench provided once the armature plate has been adjusted for optimum door gap. This will firmly secure the armature plate and prevent it from becoming loose over time

GIANNI GS250 Series Mini Shear Lock 4

Mortise Mount

  1. Make sure the gap between the door top rail and frame header is 2 mm.
  2. Mark the central lines on the door and frame where the magnet and armature assembly will be installed.
  3. Attach the templates to the door and frame.
  4. Cut and drill holes where the templates indicate. Connect the wires. Install the shear lock and armature assembly towards the leading edge of the door.
  5. Connect to the power and check the unit.

A. For proper operation, the armature assembly must be close and parallel to the shear lock, without interfering with opening and closing of the door.
Keep a distance of 2 mm between the armature assembly and the magnet.
B. If the magnet attracts the armature assembly when the door is not in position, please adjust the door operator and floor hinges.

GIANNI GS250 Series Mini Shear Lock 5

GIANNI GS250 Series Mini Shear Lock 6

GIANNI GS250 Series Mini Shear Lock 7

For Vertical Installation

GIANNI GS250 Series Mini Shear Lock 8

Connecting Diagram

Caution:
Make sure that the”+”and “-”wires are connected correctly. Please ensure the voltage selection (see Jumper Setting below) is correct for the power supply that is used. Failure to observe polarity and the correct voltage will result in damage to the product and is not covered by the warranty.

Power supply:
The product must be powered from a UL-listed regulated, power-limited, power supply.
If power switch is not wired between DC source voltage(+) and magnet, it will take a longer time to de-energize the magnet simulating residual magnetism. The minimum permissible wire size to be used shall not be less than 22 AWG.

GIANNI GS250 Series Mini Shear Lock 9

Important Notes

GIANNI GS250 Series Mini Shear Lock 10

Documents / Resources

| GIANNI GS250 Series Mini Shear Lock [pdf] Instruction Manual
GS250 Series Mini Shear Lock, GS250 Series, Mini Shear Lock, Shear Lock, Lock
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

GIANNI User Manuals

Related Manuals