GIANNI INDUSTRIES GK140 Electric Strikes Instruction Manual

June 9, 2024
GIANNI INDUSTRIES

GIANNI INDUSTRIES GK140 Electric Strikes Instruction Manual

Specifications

  • Operating Voltage: 12 or 24 VDC
  • Voltage Tolerance: ±10%
  • Current Draw: 700mA/12VDC ; 350mA/24VDC
  • Operating Temperature: 14°F to 120°F (-10°C~+49°C)
  • Humidity: 0~85% non-condensing
  • Solenoid Testing: Over 250,000 cycles
  • Preload: Up to 200 lbs
  • Static Strength: 1,200 lbs (GK140 Series) 1,000 lbs (GK145 Series)
  • Construction: Stainless steel
  • Net Weight: 673g
  • Latch Throw: GK140: 15 mm, GK145: 11 mm (With 3mm door gap)
  • Keeper Width: 48mm
  • Lock Mode: Fail-secure

Overview

Attention!
Please follow the sticker’s instruction to install the strike.

Keeper Adjustment (GK145 Only)

Keeper Adjustment

The strike keeper can be adjusted horizontally to account for various installation anomalies. To adjust the keeper, loosen the adjustment screws, move the keeper horizontally as needed, and retighten the adjustment screws. (Maximum adjustable range: 3mm)

Overview

Handing Guide

Handing Guide

Door handing is determined from the side of the door where the hinges are visible, according to the German standard DIN 107. Stand facing the door on the hinge / pull side. If the hinge is on the right, the door is considered to be DIN right. If the hinge is on the left, then the door is considered to be DIN left.

Models (M: Door Status Monitor)

DIN left DIN right
GK140-L-12 GK145-L-12
GK140M-L-12 GK145M-L-12
GK140-L-24 GK145-L-24
GK140M-L-24 GK145M-L-24

Optional Brackets

Lip extension brackets are available for wider jambs.

Optional Brackets

Mortise Mount in Wooden Frame

Wooden Frame

Wiring Diagram

Wiring Diagram

Installation Steps

  1. Measure the vertical and horizontal position of the latch bolt on the door leaf.

  2. Mark the position of the latch bolt on the door frame as shown in the figure.

  3. Mount the supplied template and align to the marked line.

  4. Drill and cut the frame according to the template.

  5. Tighten the indicated screws.

  6. Connect the wires and install the strike.

Note

It must be ensured that there is a small space between the latch bolt and actuated latch stop when the door is closed and the latch bolt is in its locked position. This will relive pressure on the solenoid valve and reduce the risk of failure when opening the door.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals