LUMASCAPE LS3040 Direct Burial Instruction Manual
- June 3, 2024
- LUMASCAPE
Table of Contents
LUMASCAPE LS3040 Direct Burial
Tools Required
Included Components
Instructions Luminaire 3 mm Allen Key
Optional Accessories
Louver
(Optional)
- Do Not Use Power Tools on Screws
- Keep Electronics Free From Dirt and Moisture
- No Downward Force
- Keep Away from Flammable Materials
- Do Not Hose or Pressure Clean
- Do Not Overtighten
- Do Not Use Silicone On Outside Surface
- Do Not Cut Cable to the Luminaire
Please read and follow all safety instructions carefully. Failure to do so
will void warranty.
WARNING
Product Warranty is void if product is not installed as per installation
instructions and in compliance with all local and provincial codes.
- Ensure installation complies with local electrical rules and regulations.
- All electrical work must be performed by a licensed electrician.
- Protective earth; protective ground (symbol 7).
- All luminaires may become hot. Use discretion on where the luminaire is mounted. Take care when setting luminaire as it may become hot.
- Luminaire should only be used complete with protective shield. If protective shield is cracked, immediately stop using luminaire. Isolate light source, keep it dry and immediately contact Lumascape for replacement of protective shield (symbol 11).
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by Lumascape or their service agent in order to avoid a hazard.
- The light source contained in this luminaire shall only be replaced by Lumascape or their service agent.
- Do not stare at the operating light source. The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 23’ (7 m) is not expected (symbol 13)
- Basic insulation has been maintained between line voltage and the control conductors.
- To reduce the risk of strangulation the flexible wiring connected to this luminaire shall be effectively fixed to the wall if the wiring is within arm’s reach.
- Ensure mains input power is surge protected.
- Never make or break connections while the circuit is energized.
- Do not make modifications or alter the product.
- Keep luminaire clean and free of debris.
- Only clean with warm water.
- Do not use chemicals or abrasives to clean luminaire as this may void the product warranty.
- Connections are to be kept clean and dry at all times.
- Suitable for use indoors or outdoors.
Assembly Instructions
Optional Glare Control Accessories
Wiring
Designations
Power Sync (4-Core) – International
Do not Hi-Pot test
Power Sync (4-Core) – North America
Do not Hi-Pot test
Dimensions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>