somogyi FLL 50 LED Spotlight Instruction Manual

somogyi FLL 50 LED Spotlight

Before use of the product, please read this instruction manual and keep it for future reference. The original document was prepared in the Hungarian language. This weatherproof LED floodlight is especially suited for the illumination of buildings and courtyards. The adjustable base allows mounting on a vertical surface.

COMMISSIONING

Attention:  The commissioning must be carried out by a specialist in compliance with the applicable safety and contact protection regulations!

Follow the steps

1. Caution:  Before installing and connecting the luminaire, disconnect the power supply!

2. Use screws and dowels to mount the luminaire on a wall with a suitable load-bearing capacity, at least 1.8 m above floor level and up to 5 m high. Choose a location that provides IP65 protection for the floodlight.

3. Remove the cover of the junction box by removing the 4 screws.

4. Unscrew the outer plastic nut from the cable gland.

5. Thread the plastic nut onto the wire and feed the wire through the gland into the junction box.

6. Connect the power cables according to the terminal block markings:

7. Screw the plastic nut tightly back onto the gland.

8. Screw the gland cover back on so that the silicone gasket is in place. Tighten the 4 screws.

9. Adjust the angle of the floodlight.

10. You can now reconnect the circuit by switching on the circuit breaker.

CLEANING, MAINTENANCE

To ensure the optimal operation of the luminaire, you need to clean it on a monthly basis at least, or when it becomes dirty.

1. Before cleaning, disconnect the luminaire from power supply.
2. Let the luminaire cool down (min. 30 minutes)
3. Clean the outside of the luminaire with a slightly damp cloth. Do not use aggressive cleaning agents! Do not let water leak inside the luminaire or spill on electrical components.

PROTECTIVE SCREEN

If the protective screen is cracked or broken, do not use the product any longer. The protective screen is not replaceable, so if it is damaged, the product must be destroyed!

TROUBLESHOOTING

supply.

WARNINGS

• Make sure that the product was not damaged during shipping.
• Always disconnect the power supply before commissioning, repair or cleaning!
• The product must be installed and repaired by qualified personnel only, in compliance with the applicable safety regulations.
• Mount it on a surface with a suitable load-bearing capacity, at least 1.8 m above floor level and up to 5 m high.
• The luminaire cannot be installed in loops.
• The luminaire must only be connected to an installed cable!
• The wire must be of H05RN-F type, and 3 x min. 1.0 mm2 cross-section!
• Always use the lamp with its protective shield!
• The protective screen is not replaceable, so if it is damaged, the product must be destroyed!
• Do not cover up the floodlight!
• The light source in the luminaire is non-replaceable. At the end of the service life of the light source, the entire luminaire must be disposed.

SYMBOLS

• Do not stare into the light of the LED!
• The lamp shade can not be replaced, so in case of its damage the entire product must be discarded.
• Please maintain the required distance from the illuminated surface (and should be 0,5 m)!
• Risk of electric shock! Do not attempt to disassemble of modify the unit or its accessories. In case any part is damaged, immediately power off the unit and seek the assistance of a specialist.

DISPOSAL

Waste equipment must be collected and disposed separately from household waste because it may contain components hazardous to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of product at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.

TECHNICAL DATA

This product contains an F energy efficiency class light source.

• power supply: 220-240 V~, 50/60 Hz
• colour temperature: 4000 K
• Meaning of class IP65: Protected against dust penetration. Protection against water jets (from any direction)
• operating temperature: -20 to +40°C

producer

• Distribútor: Somogyi Elektronic Slovensko s. r. o.
• Ul. gen. Klapku 77, 945 01 Komárno, SK,
• Tel: +421/0/35 7902400
• www.somogyi.sk

References

• Zed d.o.o.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>