IT510 Bluetooth Earbuds Instruction Manual

June 4, 2024
Earbuds

Instruction Manual

Please read the instructions before use

Connect

1. Take out the earbuds (Earbuds auto power on)

2. After open the phone Bluetooth, Click the < IT510 > to Pairing

Reset

If earbuds has any connection or function problems, please reset the earbuds

  1. Delete the BT pairing information on the phone.
  2. Put the earbuds into the charging case to charge.
  3. Take out the earbuds and wait for 20 seconds.

(If the above operation does not work, please try again)

Operation

Play /Pause            Switch Song              Adjust Volume

Power on/off (When no conected)    Answer/Hang up

Reject Call         Voice Assistant

Xl: Click Once
X2: Click 2 times
2S: Press and hold for 2 seconds

Problem handling
  1. Can be connected but there is no sound:
    Click the right earbuds to increase the volume.

  2. One of earbuds cannot be charge:
    Clean the charging contact of the earbuds and the charging case.

  3. One of the earbuds cannot be connected:
    Reset the earbuds.

If the earbuds cannot be charged, please activate the warranty and contact us to send a new product.

Please clean the charging contacts of the earbuds and charging case frequently to avoid charging failures.

Safety Instructions
  1. Keep the product away from extremely hot and cold environments, it will damage the battery and circuit.
  2. Avoid liquid immersion into the product.
  3. Do not disassemble the product.
  4. Do not use concentrated chemical products or detergents to clean the product.
  5. Use only 5V/1A power supply. Connecting the power supply voltage too high may cause serious damage.
  6. Do not randomly discard or place the product near fire or high temperature to avoid the danger of explosion.

eVatmaster Consulting GmbH
Bettinastr. 30,60325 Frankfurt am
Main,Germany
Contact@evatmaster.com

EVATOST CONSULTING LTD
Suite 11, First Floor, Moy Road, Business Centre,
Taft Well, Cardiff, Wales, CF15 7QR
Contact@evatmaster.com

Made in China

IT510 Bluetooth Earbuds Instruction certi

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause ha anfu interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals