GUNING S2 True Wireless Stereo Earbuds User Guide
- June 3, 2024
- Earbuds
Table of Contents
S2 True Wireless Stereo Earbuds
User Guide
Control
| Play/Pause | x1 | or | x1 |
|---|---|---|---|
| Previous Track | x2 | ||
| Next Track | x2 | ||
| volume up | Press and hold(Single mode) | ||
| Answer Call | x1 | Or | x1 |
| End Call | x1 | Or | x1 |
| Reject call | x2 | Or | x2 |
| ANC/Normal/Transparency | Press and hold(TWS) | or | Press and hold(TWS) |
| Enable/Disable Voice Assiastant | x3 | or | x3 |
HOW TO PAIR?
- Put S2 into the charging case
- Close the charging case
- Open the charging case.S2 will enter pairing mode automatically
- Select GUN ING S2 from devices list of the phone
- Connected
DEVICE LAYOUT
- LED Indicator
- Touch Key
- Microphone
- In Ear dectection point
- Charging/Communition PIN
HOW TO WEAR?
- Choose the suitable eartips
- Insert s2 into the ears
- Twist slightly until it fits well
HOW TO WORK
Music:| Music will be paused/resumed automatically when a earbud is taken
out/wear. When two earbuds are taken out all, music will stop playing.
---|---
Calling:| When two earbuds are taken out all,The calling will be switched from
earbuds to the phone
ONIOHVHO
MULTIFUNCTION KEY
| Led Brightness Adjust | xl |
|---|---|
| TWS Bonding | x2 |
| Disconnected | Press and hold 3seconds |
| Reset All | Press and hold 8seconds |
WHAT IS INSIDE
- S2 Earbuds
- Charging case
- S/M/L Silicone tips
- USB TYPE-C cable
- Quick start guide
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
NEED HELP?
[email protected](US/CA)
[email protected](JP)
[email protected](UK/DE/FR/IT/SE)