VISUAL COMFORT BBL 5182 Sash Large Hanging Shade Installation Guide

VISUAL COMFORT BBL 5182 Sash Large Hanging Shade

Sash Large Hanging Shade
Item # BBL 5182

NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with its construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install it. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Wire Cutters
• Slotted Screwdriver
• Wire Strippers
• Measuring Tape

ASSEMBLY INSTRUCTIONS

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from the canopy (F) by removing the collar ring (G).

3. Install mounting plate (B) to the junction box and secure it with mounting screws (C).

4. Feed hanging cable through collar ring (G), canopy (F), and mounting plate (B).

5. Adjust the hanging cable to the desired length. Install cable lock (H) to the hanging cable and tighten ends with a screwdriver as shown in diagram 1.

6. After fixture height is achieved shorten the hanging cable by using a pair of cutters.
   NOTE: Make sure the fixture height is accurate before cutting the cable.

7. Loosen set screw (E) on wire stop (D), then feed fixture electrical wire through the canopy (F) and wire stop (D). Adjust the wire to the desired length then tighten set screw (E).
   NOTE: Make sure there is no tension on the electrical wire when the fixture is fully extended.

8. Cut excess wire, being sure to leave enough to reach the junction box.

9. Remove the outer housing of the wire by making a neat cut all the way around, about 1” from the end. Once the cut is made, remove and discard the 1” piece of housing, exposing the electrical wires.
   NOTE: Make sure not to cut too deep into the housing or electrical wires could become damaged.

10. Separate wires, and strip insulation on each 5/8″.

11. Wrap fixture ground wire (green) around the green grounding screw (see diagram 2). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A). NOTE: It is imperative that the fixture is grounded.

12. Connect the fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).

13. Connect the fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

14. Make sure all wire connections are tight, then carefully tuck them into the junction box.

15. Install canopy (F) to mounting plate (B) and secure with collar
    ring (G).

16. Remove finial (L) from nipple (I), install shade (J) and diffuser (K) to nipple (I), and secure with a finial (L).

17. Install light bulbs into the sockets.

Care Instructions

Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>