LEDone LOC-MUFL Series LED Installation Guide
- June 3, 2024
- LEDone
Table of Contents
LOC-MUFL Series
Installation Guide
SAFETY INSTRUCTIONS:
Read instructions carefully before attempting to install fixture.
- All wiring should be performed by a qualified electrician.
- Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances.
- Proper grounding is required to ensure personal safety.
- Recommended to be stored in -10°C to 60°C (14°F to 140°F).
CAUTION: Risk of fire
- WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
- WARNING: Risk of shock when photoelectric switch is provided.
- WARNING: Please check if the voltage marked on the luminaire is consistent with the input voltage to be connected.
- WARNING: Do NOT use in an area with strong acid mist.
- WARNING: Make sure the installation position can withstand 10 times the weight of the luminaire before installing.
o Install it at a flat place without vibration, swinging or fire hazards.
CLEANING & MAINTENANCE:
CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.
- Clean glass lens with non-abrasive glass cleaning solution.
- Do NOT open fixture to clean the LED. Do NOT touch the LED.
Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during installation, operation or maintenance.
TROUBLESHOOT:
- If the light will not come on:
o A. Light switch is turned off. Turn light switch on.
o B. Fuse is blown, or circuit breaker is turned off. Replace fuse or turn circuit breaker on.
o C. Incorrect circuit wiring. Verify that fixture is wired properly.
WIRING:
Universal voltage driver permits operation at 120V through 277V, 50/60Hz. For
0-10V dimming, follow the wiring diagram in the drawing.
- Connect the BLACK fixture lead to the (+) LINE supply lead.
- Connect the WHITE fixture lead to the (-) COMMON supply lead.
- Connect the GROUND wire from fixture to supply ground. Do NOT connect the GROUND of the dimming fixture to the output.
- Connect the PURPLE fixture lead to the (V+) DIM lead.
- Connect the GRAY fixture lead to the (V-) DIM lead.
- Cap the YELLOW fixture lead, if present. Do NOT connect.
MOUNTING:
- TRUNNION MOUNTING : Follow mounting directions below.
a. Drill holes to prepare for mounting. (Image 1)
b. Mount fixture with screws. (Image 2)
c. Connect the wires as mentioned above. (Image 3)
d. Use side screw to adjust bracket angle. (Image 4)
`
Phone: (844) LEDONE6
Fax: 1-510-217-9461
Web: www.ledonecorp.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>