FIAMMA 98655Z101/98655Z102 Brackets Kit Installation Guide
- June 3, 2024
- FIAMMA
Table of Contents
KIT
FIAT DUCATO H2
L2 / L3 (≥ 2006)
98655Z101 / 98655Z102
F80s – F65s (320-370 cm)
Installation instructions for brackets
98655Z101/98655Z102 Brackets Kit
LHD
|
RHD
---|---
Left-hand drive
|
Right-hand drive
Package contents
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
The awnings are to be fi xed on the brackets so that the words “SUPPORT” on the
awning are in correspondence of the brackets: this condition is necessary and
indispensable for the two brackets situated at the extremities (which are
located on the fi xing point of the arms on the case-box). It is important, but
not indispensable, for the central bracket/s as it/they provide/s only a
mounting support.
The brackets must always be well-aligned to each other to avoid later
problems; in case they are not, they must be properly shimmed using the
spacers to ensure the alignment.
The installation of the awning can occur only when the brackets are perfectly
aligned to the roof of the vehicle.
Attention: to fix the brackets, use exclusively the hookings that are on the vehicle.
SIKA 252
Important: use of SIKA 252 adhesive is essential for fi xing the bracket
(brackets).
Attention Security.
Remove this label only after fi xing the awning on the adapter.
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are fi rmly
attached (especially after the first kilometers) make sure the bolts are not
loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed.
Checking that the wall/roof/rear door is suffi ciently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce it these
points.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer
is entitled to the warranty in accordance with local laws and regulations of
the country in which the product was purchased.
More information https://www.caravansplus.com.au
https://www.fiamma.it/en/
fiamma.com
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time,
without notice, prices, materials,
specifi cations and models or to cease
production of any model.
R0_IS_98691-043_revA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>